Laserfiche WebLink
D. Results of Testing/Servicing 06 R E C E IN d -3 <br /> Software Version Installed: 329.01 JUN 15 2017 <br /> :ora tete the followinq checklist: <br /> ® Yes ❑ No' Is the audible alarm operational? r <br /> ® Yes [I No* Is the visual alarm operational? <br /> ❑ Yes ® No* Were all sensors visually inspected,functionally tested,and confi <br /> ggAff, #ENT <br /> ® Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper <br /> operation? <br /> ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.,modem)operational? <br /> ® N/A <br /> ® Yes ❑ No• For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak, <br /> ❑ NIA fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut-down? (Check all that apply) H SumpRrench <br /> Sensors; ®Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due M leaks and sensor failure/disconnection? ®Yes; ❑No. <br /> ❑ Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e., no mechanical overall prevention valve is <br /> ® N/A installed),is the overfill warning alarm visible and audible at the tank fill point(s)and operating properly? If so,at what percent of tank capacity <br /> does the alarm trigger? 0% <br /> ❑ Yes IN No Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replaced and list the manufacturer name <br /> and model for all replacement parts in Section E,below. <br /> []Yes* ® No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> ❑Product; ❑Water. If yes,describe causes in Section E,below. <br /> ® Yes ❑ No" Was monitoring system set-up reviewed to ensure proper settings?Attach setup reports,if applicable <br /> ® Yes ❑ No* s all monitoring equipment operational per manufacturer's specifications? <br /> •In Section E below,describe how and when these deficiencies were or will be corrected. <br /> VICKI ON SITE .WITH EH . 87 ANN SPACE 407 SENSOR DOES NOT WORK . ELITE WILL REPLACE <br /> E. comments: AND RETES. <br /> Monitoring System CerOflcation Page 2 of 4 2/21/07 <br />