Laserfiche WebLink
D. Results of Testing/Servicing <br />Software Version Installed: <br />rn iera Lite <br />iunuwut utet,nuai. <br />es <br />❑ No' <br />Is the audible alarm operational? <br />es <br />❑ No' <br />Is the visual alarm operational? <br />e <br />❑ No` <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />es <br />❑ No` <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper <br />operation? <br />❑ Yes <br />❑ No' <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g., modem) operational? <br />lA <br />Yes <br />El No' <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment monitoring system detects a leak,, <br />Ga- ump/Trench <br />❑ NIA <br />fails to operate, Lws electrically disconnected? If yes: which sensors initiate positive shut -down? (Check all that apply) <br />Sensors, OJMspenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor failure/disconnection? �—❑ No. <br />❑ Yes <br />El No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e., no mechanical overfill prevention valve is <br />/A <br />installed), is the overfill warning alarm visible and audible at the tank fill point(s) and operating properly? If so, at what percent of tank capacity <br />does the alarm trigger? % <br />❑ <br />o <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the manufacturer name <br />ano model for all replacement parts in Section E, below. <br />Yes <br />x <br />❑ <br />o <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br />❑ Product; ❑ Water. If yes, describe causes in Section E, below. <br />Yes <br />' <br />es <br />r❑ No' <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set up reports, if applicable <br />. <br />uk_-s <br />❑ No' <br />I Is all monitoring equipment operational per manufacturer's specifications? <br />" In Section E below, describe how and when these deficiencies were or will be corrected. <br />Comments: <br />i <br />Monitoring System Certification Page 2 of 4 2/21/07 <br />