Laserfiche WebLink
Composition <br />Joining system <br />Pipe lengths <br />Fittings <br />K <br />Primary operating pressures to 300 psi (20 bar) <br />Continuous operating temperature to 150°F (66°C) <br />Containment system Listed by Underwriters Laboratories to 75 psi (5 bar) <br />Individual system components may not have the same ratings as the pipe. Refer to the <br />detailed product information for the specific components to determine the pressure <br />rating for the system as a whole. <br />Primary pipe: Filament -wound fiberglass reinforced epoxy pipe with integral epoxy liner <br />and exterior coating. When classified in accordance with ASTM D2310 and ASTM <br />D2996, the pipe meets the following cell limits: RTRP 11 CX -5430. <br />Pipe containment: Filament -wound fiberglass reinforced epoxy pipe. <br />Interstitial space: Dry sand particles (10-20 mesh) secured in place with adhesive <br />backed polypropylene tape. <br />Fittings: Compression molded or filament -wound fiberglass reinforced epoxy primary <br />fittings. Containment fittings are filament -wound fiberglass reinforced epoxy. <br />Adhesive: Ameron B20 ambient -cure, two-part epoxy for all services (including alcohols) <br />Primary: Bell and spigot taper/taper adhesive -bonded joint <br />Containment: 6 TPI (threads per inch) modified ACME threaded joints with O-ring <br />gasket seals. Injection molded parts are made of acetal co -polymer listed by U.L. <br />Seals are U.L. Recognized nitrile rubber compound. <br />Standard 20 ft. (6.1 m) random lengths 17 to 21 ft. (5.2 to 6.4 m) <br />and 27 ft. (8.2 m) random lengths 25 to 27 ft. (7.6 to 8.2 m) <br />Other lengths available upon request. <br />Primary- Adapters: bell x NPT male' <br />Adapters: bell x NPT female2 <br />Adapters: spigot x NPT female2 <br />Adapters: spigot x NPT male2 <br />450 elbows' <br />900 elbows' <br />End caps' <br />Flange rings' <br />Flange stub ends' <br />Isolation bushings' <br />Nipples2 <br />Reducer bushings' <br />Repair couplings' <br />Sleeve couplings2 <br />Tees' <br />Dispenser pan penetration fittings' <br />Containment- 45° elbows Termination tees <br />900 elbows Couplings4 <br />Tees Termination assemblies2 <br />Reducers Jumpover assemblies (fee x 45° elbows) <br />1 Molded fitting <br />2 Filament -wound fitting <br />3 Other fittings available without UL Listing <br />4 Filament -wound or injection molded outer layer, molded outer layer is separate <br />5 Not yet Listed by U.L; for 3- and 4 -inch sizes only <br />