Laserfiche WebLink
D. Results of Testing/Servicinz <br />Software Version Installed: <br />Comalete the following checklist: <br />YesMC3No* <br />e audible alarm operational? <br />visual alarm operational? <br />se <br />jIsthe <br />all sensors visually inspected, functionally tested, and confirmed operational? <br />Yese <br />all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br />nterfere with their proper operation? _ <br />Cl Yes ❑ * <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />:--N/A <br />operational? <br />❑ Yes No* <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />❑ /A <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br />positive shut -down? (Check all that apply) ❑ Sump/Trench Sensors; ❑ Dispenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks and sensor failure/disconnection? ❑ Yes; ❑ No. <br />❑ Yes ❑ No* <br />For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br />❑ N/A <br />mechanical overfill prevention. valve is installed), is the overfill warning alarm visible and audible at the tank <br />fill point(s) and operating properly? If so, at what percent of tank capacity does the alarm trigger? % <br />❑ Yes* ❑ No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />and list the manufacturer name and model for all replacement parts in Section E, below. <br />❑ Yes* Cl No <br />Was liquid found inside any secondary containment systems designed as dry systems? (Check all that appl}) <br />❑ Product; ❑ Water. If yes, describe causes. in Section E, below. <br />❑ Yes ❑ No* <br />Was monitoring system set-up reviewed to ensure proper settings?. Attach set up reports, if applicable <br />❑ Yes ❑ No* <br />Is all monitoring equipment operational per manufacturer's specifications? <br />._fl i- -1-A <br />* In Section E below, aescrlDe now anu w,ieu uAcPc UK;AMac■...11 <br />— <br />E. Comments: <br />Au—rPC3rot", 3 1IJck Cif�,k.' "t off„}61 <br />ye A I A M e 4k 11: <br />CnA-9V v\ <br />