Laserfiche WebLink
Feb 07 05 01 : 03P Rff da-Test (20PI 794-0112 P. 3 <br /> D. Results of Testing/Servicing <br /> Software Version Installed: <br /> Co 9 <br /> et e the following checklist: <br /> s ❑ No* Is the audible alarm operational? <br /> es ❑ No* Is the visual alarm operational? <br /> s ❑ No* Were all sensors visually inspected, functionally tested,and confirmed operational? <br /> Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> operational? <br /> Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ NIA monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) ❑�p/Trench Sensors; $'L—ispenser Containment Sensors. <br /> Did you confi positive shut-down due to leaks and sensor failure/disconnection? 0-'1 es; ❑No. <br /> Yes D No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> ❑ N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fill point(s) and operating properly? If so,at what percent of tank capacity does the alarm trigger? f �% <br /> ❑ Yes* o Was any monitoring equipment replaced? If yes, identify specific sensors,probes, or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E,below. <br /> ❑ Yom* o Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) <br /> ❑Product; ❑ Water. If yes, describe causes in Section E,below. <br /> Y s- ❑ No* Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> Yes ❑ No* Is all monitoring equipment operational per manufacturer's specifications? <br /> * In Section E below, describe how and when these deficiencies were or will be corrected. S <br /> E. Comments: I t-t V o "' Y"I/) 07 1 t C� ✓1 <br /> /a t--v�2 Z i S ie -.1 , �a b -7-, <br />