Laserfiche WebLink
Bonded Sump Entry Fitting - Termination Style <br />for Fuel Handling applications <br />Installation and Application Instructions <br />1. Determine entry hole location and cut entry hole in sump <br />wall using appropriate "C" dimensions in Table 1. <br />2. Using 40-60 grit fresh emery cloth or sand paper, sand <br />the sump wall surfaces, inside and outside, to the outside <br />diameter of the alignment rings. All glazed surface must <br />be removed. Once finished sanding, remove all dust <br />from the sanded area with a clean, dry cloth or brush. <br />Do not use compressed air or bare fingers. <br />3. Place two alignment rings on sump entry fitting and <br />insert through sump wall from outside the sump. Locate <br />the 1/4 inch threaded outlet to the desired angular <br />location. <br />If this fitting is used in an Open (Drainage) System, <br />locate the 1/4 inch threaded outlet in the 6 o'clock <br />position. <br />Leave 1/4 inch plastic threaded outlet protector in place <br />until 1/4 inch fitting installation. <br />4. Dry fit primary pipe and rotate the two rings until the <br />desired angle is reached. Maximum allowable offset is <br />5°. <br />Make alignment marks on the rings, the sump entry <br />fitting, and the sump wall. Be sure to mark the rings so <br />they can be placed in the same location and sequence <br />during bonding. <br />Size <br />A <br />B <br />C <br />Inch <br />Inch <br />Inch <br />Inch <br />3 x 2 <br />6.88 <br />4.00 <br />4.00 <br />4 x 3 <br />6.88 <br />4.00 <br />5.00 <br />NOTE: These fittings can only be bonded to flat walled, <br />fiberglass sumps. DO NOT install on thermoplastic or <br />round sumps. <br />-Part <br />Red Thread IIA or 012030-626-0 012040-626-0 <br />Dualoy 3000/L <br />Dualoy 3000/LCX` 22856830 33856830 <br />Includes Closure Nipple <br />SUMP WALL <br />OUTSIDE <br />SUMP <br />INSIDE <br />SUMP A <br />B <br />T --�_F <br />C <br />HOLE <br />DIA --L---_ <br />RETAINING ALIGNMENTy ENTRY TERMINATION <br />RING RINGS FITTING BODY <br />Fiber Glass Systems <br />