Laserfiche WebLink
ORGANIC GLOSSARY OF DATA OL'ALIFIERS AIND ABBRENJ ATIONS <br /> 0!:ganic Data Qualifiers <br /> A TIC is a suspected aldol-condensation product <br /> B Compound was found in the associated blank and the sample <br /> C Pesticide identification was confirmed by GC/MS <br /> D Concentration values reported at a secondary dilution factor, or surrogate or matrix spike recoveries <br />' were not obtained because the extract was diluted for analysis <br /> E Concentration exceeds the instrument calibration range and was subsequently diluted <br /> I Appears on the "results spreadsheet" and "quant reports" to indicate an Interference, or it appears on <br /> pesticide Form 8 to indicate an instrument blank without a surrogate <br /> ] Result is an estimated value below the reporting limit, or a Tenativeiy Identified Compound (TIC) <br /> N Indicates presumptive evidence of a Tentatively Identified Compound (TIC) <br /> P The percent difference between the results from two GC columns is greater than 25%, and the lower <br /> of the two values is reported <br /> T Compound was found in the associated TCLP extraction blank and the sample <br />' U Compound was analyzed for but not detected at or above the reporting limit <br /> X Laboratory-defined qualifier description included in the narrative <br /> * QC result was outside the laboratory control limits <br /> Abbreviations <br /> BS Blank Spike spike analysis was conducted on reagent grade water or a matrix free from the analyte(s) <br /> of interest <br /> BSD Blank Spike Duplicate <br /> BRL Below Reporting Limit <br /> CD Calculation Factor used by the Laboratory's Information Management System (LIMS) <br /> DF Dilution Factor <br /> DL Appears in the sample ID to indicate a secondary dilution <br /> LCS or (LC) denotes Laboratory Control Standard <br /> MB Method Blank or (P$) preparation blank <br /> MS Matnx Spike <br /> MSD Matrix Spike Duplicate <br /> NA Not Applicable <br /> NC Not Calculated <br /> NR Not Required <br /> NS Not Spiked <br /> RE Appears in the sample ID to indicate a Re-analysts <br /> REP Replicate analysis <br /> REPREP Sample was reprepared and then reanalyzed <br /> RFW# Equivalent to the laboratory sample identification (LAB ID) <br /> RPD Relative Percent Difference of duplicate analyses <br /> RRF Relative Response Factor <br /> RT Retention Time <br /> RTW Retention Time Window <br /> NOTES <br />' One or a combination of these data qualifiers and abbreviations may appear in the analytical report <br /> o Soil sediment and sludge results are reported on a dry weight basis except when analyzed for landfill disposal or incineration <br /> parameters All other results on a solid mainx are reported on an as received" basis unless noted differently <br /> o Reporting limits are adjusted for preparation sample size sample dilutions and sample moisture content if analvzed on a do <br /> weight basis <br /> Re%iseLi 07 01 94 <br />