Laserfiche WebLink
L-10RGANIC GLOSSARY OF DATA QUALIFIERS AND ABBRE`'IATIONS <br /> Inoreamc Data Qualifiers <br /> B Result is less than the CRDL, but greater than or equal to the IDL <br /> E Result is estimated because of the presence of interference <br />' M The RSD of duplicate maections exceeded 20% for analyte concentrations greater than the CRDL <br /> N Matrix Spike recovery was outside the control limits <br /> S Result was determined by the Method of Standard Additions (MSA) <br /> T Analyte was found in the associated T'CLP extraction blank and sample <br /> U Analyte was analyzed for but not detected at or above the IDL (for CLP analysis), or at or above the <br /> reporting limit for non-CLP analysis <br /> W Post-digestion spike was outside the control limits (85-115%), and the sample absorbance is less than <br /> 50% of the spike absorbance <br /> + The correlation coefficient for the MSA is less than 0 995 <br /> Duplicate analysis (or QC result) was outside the control limits <br /> Method Oualifiers <br /> A Analyzed by flame A A direct aspiration <br /> C Analyzed by manual spectrophotometric method for Cyanide <br /> CV Analyzed by manual cold vapor generation A A for Mercury <br />' F Analyzed by graphite fiumace atomic absorption spectroscopy <br /> P Analyzed by inductively coupled argon plasma <br /> Abbreviations <br /> BS Blank Spike spike analysis was conducted on reagent grade water or a matrix free from the analyte(s) <br /> of interest <br /> BSD Blank Spike Duplicate <br /> BRL Below Reporting Limit <br /> CCV Continuing Calibration Verification <br /> CCB Contmumg Calibration Blank <br /> CD Calculation Factor used by the Laboratory's Information Management System (LIMS) <br /> DF Dilution Factor <br />' ICV Initial Calibration Verification <br /> ICB Initial Calibration Blank <br /> LCS or (LC) denotes Laboratory Control Standard <br /> MB Method Blank or (PB) for Preparation Blank <br /> MS Matrix Spike <br /> MSD Matrix Spike Duplicate <br /> NA Not Applicable <br /> NC Not calculated <br />' NR Not Required <br /> NS Not Spiked <br /> REP Replicate analysis <br /> RFW# Equivalent to the laboratory sample identification (LAB ID) <br /> RPD Relative Percent Difference of duplicate analyses <br /> X Laboratory-defined qualifier description included in the narrative <br /> NOBS <br /> • One or a combmauon of these data qualifiers and abbreviations may appear m the analytical report <br /> • Soil sedunent and sludge results are reported on a dry weight basis except when analyzed for landfill disposal or incineration <br /> parameters All other results on a solid matrix are reported on an as received'basis unless noted dtffertntly <br /> ° Repomng limits are adjusted for preparation sample size sample dilutions and sample moisture content if analyzed on a dry <br /> weight basis <br /> Rc%tied 07/01/94 <br />