Laserfiche WebLink
ORGANIC GLOSSARY OF DATA QUALIFIERSA_h'D ABBRENZATIONS <br /> Oreanic Data Ouaitfie_rs <br /> . A TIC is a suspected aldol-condensation product <br /> B Compound was found in the associated blank and the sample <br /> C Pesticide identification was confirmed by GC/MS <br /> D Concentration values reported at a secondary dilution factor, or surrogate or matrix spike recoveries <br /> were not obtained because the extract was diluted for analysis <br /> E Concentration exceeds the instrument calibration range and was subsequently diluted <br /> I Appears on the "results spreadsheet" and "quant reports" to indicate an interference, or it appears on <br /> pesticide Form 8 to indicate an instrument blank without a surrogate <br /> J Result is an estimated value below the reporting limit, or a Tenat vely Identified Compound (TIC) <br /> N Indicates presumptive evidence of a Tentatively Identified Compound (TIC) <br /> P The percent difference between the results from two GC columns is greater than 25%, and the lower <br /> of the two values is reported <br /> T Compound was found in the associated TCLP extraction blank and the sample <br /> U Compound was analyzed for but not detected at or above the reporting limit <br /> X Laboratory-defined qualifier description included in the narrative <br /> " QC result was outside the laboratory control limits <br /> Abbreviations <br /> BS Blank Spike spike analysis was conducted on reagent grade water or a matrix free from the analyte(s) <br /> of interest <br /> BSD Blank Spike Duplicate <br /> BRL Below Reporting Limit <br /> CD Calculation Factor used by the Laboratory's Information Management System (LIMS) <br /> DF Dilution Factor <br /> DL Appears in the sample ID to indicate a secondary dilution <br /> LCS or (LC) denotes Laboratory Control Standard <br /> MB Method Blank or (PB) preparation blank <br /> MS Matrix Spike <br /> MSD Matrix Spike Duplicate <br /> NA Not Applicable <br /> NC Not Calculated <br /> NR Not Required <br /> NS Not Spiked <br /> RE Appears in the sample ID to indicate a Re-analysis <br /> REP Replicate analysis <br /> REPREP Sample was reprepared and then reanalyzed <br /> RFW# Equivalent to the laboratory sample identification (LAB ID) <br /> RPD Relative Percent Difference of duplicate analyses <br /> RRF Relative Response Factor <br /> RT Retention Time <br /> RTW Retention Time Window <br /> NOTES <br /> ° One or a combination of these data qualifiers and abbreviations may appear to the analytical report <br /> ° Sod sediment and sludge results are reported on a dry weight basis except when analyzed for landfill disposal or incineration <br /> parameters All other results on a solid matrix are reported on an "as received"basis unless noted differently <br /> Reporting limits are adjusted for preparation sample size sample dilutions and sample moisture content if analvzed on a dr% <br /> weight basis <br /> Reused 07 03 94 <br />