Laserfiche WebLink
27 <br />LOG OF TEST PROCEDURES <br />(Supplemental) <br />30. HYDROSTATIC <br />PRESSURE <br />CONTROL <br />31. <br />MT <br />VOLUME MEASUREMENTS <br />RECORD TO .001 GAL. <br />34. <br />TEMPERATURE COMPENSATION <br />USEFACTOR(a) <br />38. NET VOLUME <br />CHANGING <br />EACH READING <br />39. <br />ACCUMULATED <br />CHANGE <br />28• <br />DATE <br />Record details of setting up <br />and running test. (Use full <br />of line if needed.) <br />29. <br />Reading <br />No <br />Standpipe level <br />in Inches <br />32• Product in <br />Graduate <br />33. Product <br />Replaced (-) <br />35. <br />Thermal <br />Sensor <br />Reading <br />36. <br />Change <br />Higher • <br />g <br />Lower - <br />Ic) <br />37. <br />Computation <br />(c) • (a) = <br />Expansion • <br />Contraction - <br />Temperature <br />Adjustment <br />At Low Level Computelength <br />Chane er Hour <br />(NFPA criteria) <br />Volume Minus <br />Expansion 1.1 or <br />Contraction (-) <br />033(V) — tr37(T) <br />rinning <br />ofwhichBefore <br />ading <br />Level to <br />Restored <br />Reading <br />After <br />Reading <br />Product <br />Recovered (•) <br />TIME <br />(24 hr.) <br />2 <br />�-� Nc� IZ•. <br />+,2- <br />33 <br />12 <br />\\O <br />1 n <br />tO2 <br />4-.(9(4 <br />1Z <br />11 <br />( <br />i- <br />+-,DL <br />to S <br />.3-2-0 <br />+020 <br />36, <br />12, <br />Zo <br />`too <br />PboItori� <br />1 410 <br />ttf <br />► <br />-+.��5 <br />-F o i -1- <br />J �+o <br />Z <br />0 <br />0 LI <br />oil <br />— <br />3 <br />D L4'1 <br />313 <br />/Z <br />0 <br />5-3 D- <br />0��i <br />►? <br />+3 <br />�o <br />so <br />ar <br />4. <br />-4,031 <br />23 <br />cq'i - N o] • 0 014 S l <br />P -T Tank Test Data Chart <br />Additional Info <br />1. Net Volume Change at Conclusion of Precision Test —gph <br />Signature of Tester: <br />Date: <br />PN6829 <br />2. Statement: <br />❑ Tank and product handling system has been tested tight <br />according to the Precision Test Criteria as established by <br />N.F.P.A. publication 329. This is not intended to indicate <br />permission of a leak. <br />OR <br />❑ Tank and product handling system has failed the tank tightness <br />test according to the Precision Test Criteria as established by <br />N.F.P.A. publication 329. <br />It is the responsibility of the owner and/or operator of this <br />system to immediately advise state and local authorities of any <br />implied hazard and the possibility of any reportable pollution to <br />the environment as a result of the indicated failure of this <br />system. Heath Consultants Incorporated does not assume any <br />responsibility or liability for any loss of product to the <br />environment. <br />Tank Owner/Operator <br />Date <br />.i3 <br />