Laserfiche WebLink
Lancaster Laboratories <br /> • Where quality is a science. <br /> Page 1 of 2 <br /> ELancaster Laboratories Sample No. WW 3832622 <br /> Collected:06/05/2002 19:28 by RRM Account Number: 10869 <br /> ESubmitted: 06/08/2002 09:50 ChevronTexaco <br /> Reported: 06/20/2002 at 20 :21 6001 Bollinger Canyon Rd L4310 <br /> Discard: 07/21/2002 San Ramon CA 94583 <br /> MW-10-W-020605 NA Water <br /> Facility# 90557 SIRC <br /> 139 S Center St-Stockton T0607700391 MW-10 <br /> SCS10 <br /> As Received <br /> CAT As Received Method Dilution <br /> No. Analysis Name CAS Number Result Detection Units Factor <br /> Limit <br /> 01728 TPH-GRO - Waters n.a. 66. 50. ug/l 1 <br /> The reported concentration of TPH-GRO does not include MTBE or other <br /> gasoline constituents eluting prior to the C6 (n-hexane) TPH-GRO range <br /> start time. <br /> A site-specific MSD sample was not submitted for the project. A LCS/LCSD <br /> was performed to demonstrate precision and accuracy at a batch level_ <br /> The vial submitted for volatile analysis did not have a pH a 2 at the time <br /> of analysis. Due to the volatile nature of the analytes, it is not <br /> appropriate for the laboratory to adjust the pH at the time of sample <br /> receipt. <br /> 05553 TPH - DRO CA LUFT (Waters) n.a. 360. 50. ug/l 1 <br /> According to the California LUFT Protocol, the quantitation for Diesel <br /> Range Organics was performed by peak area comparison of the sample pattern <br /> to that of our #2 fuel oil reference standard (between c10 and C28 normal <br /> hydrocarbons) . <br /> Site-specific MS/MSD samples were not submitted for the project. A LCS/LCSD <br /> was performed to demonstrate precision and accuracy at a batch level. <br /> I01412 Methanol and Ethanol <br /> 01414 Methanol (by Direct Injection) 67-56-1 N.D. 200. ug/l 1 <br /> 02500 TPH Fuels by GC (Waters) <br /> i <br /> 02501 Total TPH n.a. 430. 400. ug/l 1 <br /> 02508 TPH Motor Oil C16-C36 n.a. 430. 400. ug/l 1 <br /> TPH quantitation is based on peak area comparison of the sample pattern to <br /> that of a hydrocarbon component mix calibration in a range that includes <br /> CO (n-octane) through C40 (n-tetracontane) normal hydrocarbons. <br /> Site-specific MS/MSD samples were not submitted for the project. A LCS/LCSD <br /> was performed to demonstrate precision and accuracy at a batch level. <br /> I 01594 BTEX + Oxygenates by 8260E <br /> 01587 Ethanol 64-17-5 N.D. 50. ug/l 1 <br /> 10 <br /> 02010 Methyl t-butyl ether 1634-04-4 0.5 0.5 ug/l 1 <br /> 02011 di-Isopropyl ether 108-20-3 N.D. 0.5 ug/l 1 <br /> Lancaster Laboratories,In C. <br /> MEMBER 2475 New kofland Pike <br /> B <br /> La ox <br /> � <br /> La cast(-r, <br /> r,PA PA 17605-1425 <br /> 717-656 2300 Fax 717-656-2681 2216 gey, 9 ,1100 <br />