Laserfiche WebLink
kn KLEINFELDER <br /> 4. The sample is labeled and immediately stored in an iced cooler pending transport to the <br /> analytical laboratory. The sample is logged on a chain-of-custody. <br /> G-7 Surface Water Monitorine <br /> 1. Prior to collecting surface water samples, the depth of water is estimated at a designated <br /> location in the surface water body. <br /> 2. Surface water samples are collected directly from the stream or surface water using a <br /> clean unpreserved plastic bottle, disposable bailer, bailer, coliwasa, DipstikTM, dipper, <br /> peristaltic pump, etc., or by directly filling the sample containers. Sampling equipment <br /> ' will either be disposable, dedicated or decontaminated in accordance with the above- <br /> defined decontamination protocols. Care is taken not to disturb the stream bottom and <br /> introduce sediment in the sample. The fluid is then poured into appropriate preserved or <br /> ' unpreserved bottles for the requested analysis. <br /> 3. The sample is labeled and immediately stored in an iced cooler pending transport to the <br /> ' analytical laboratory. The sample is logged on a chain-of-custody. <br /> ' G-8 TANK REMOVAL SAMPLING <br /> G-8.1 Collection of Soil Samples and Laboratory Analysis <br /> Soil and water samples will be collected during the tank removal operations in accordance with <br /> the current Leaking Underground Fuel Tank Field (LUFT) Manual and the Tri-Regional <br /> ' Guidelines issued by the California Regional Water Quality Control Board (RWQCB). <br /> A Kleinfelder, environmental geologist will be on site during the tank removal activities to collect <br /> soil samples for qualitative field screening and laboratory analysis. Tank excavation soil samples <br /> ' will be obtained by scraping the sidewalls or excavation bottom at the desired locations with the <br /> backhoe bucket. Samples will then be collected from the bucket by packing soil in a clean brass <br /> ' tube with a clean hand trowel. The soil samples may also be collected using a slide hammer lined <br /> with a clean brass tube with appropriate extension to reach the desired sampling depth. The <br /> collected brass tubes will then be sealed with Teflon sheets and tight fitting plastic caps. <br /> G-8.2 Collection of Water Samples and Laboratory Analysis <br /> If water is encountered in the excavation after the tank is removed, a representative sample will be <br /> ' collected for laboratory analysis. The tank excavation may be purged and allowed to refill before <br /> sampling. The water sample will be collected using a clean disposable bailer with new nylon <br /> cord. The bailer will be retrieved and the water will be contained in appropriate bottles supplied <br /> ' by the analytical laboratory for the requested analysis. <br /> In accordance with the Tri-Regional Guidelines one water sample will be collected from the tank <br /> ' excavation. The water sample will be delivered under chain-of-custody procedures to a state <br /> certified laboratory. <br /> 42162.E01 /ST04R854 Page G-7 <br /> ' Copyright 2004,Kleinfelder,Inc. July 1,2004 <br />