Laserfiche WebLink
A) Preparing the Fitting &FRP wall <br />A.1) Prepare your fittings by identifying the parts. Clean the surfaces of all fittings with <br />trichloroethylene or acetone to remove any contamination. Hand sand with 60 -grit sandpaper if <br />necessary. Do not lay them on dirt, water, debris or other contaminated surfaces. When dusting off, <br />use a shop brush, chip brush or compressed air. Do not use rags, cloth or cloth -like material <br />DRY -FIT YOUR FITTINGS TO BE SURE THAT THEY ALIGN <br />PROPERLY. <br />DO NOT PLAN HOLE SAW CUTS ON UNEVEN SURFACES. <br />FLAT PANELS ONLY. CAREFUL OF CORNERS AND EDGES. <br />YOU CAN NOT MOUNT FITTINGS ON ROUND SURFACES. <br />A.2) Dust off Sump walls (inside and out) and drill your pilot holes centered on the planned fitting <br />locations using a 1/4" Drill bit. Proceed when done to cut your holes with 2-1/2" size hole saw with <br />1/4" centralizer. Hand -sand the rough edges inside and outside made by the hole saw. <br />.JUN 0 8 2017 <br />ALL SUMPS AND BRAVO SYSTEMS FIBERGLASS F -SERIES <br />FITTINGS MUST BE KEPT FREE OF CONTAMINANTS, <br />ESPECIALLY DIRT AND WATER OR MOISTURE. <br />APPLY MEASURES TO KEEP THE INSTALLED FITTINGS DRY <br />WHEN LEFT OVERNIGHT ON-SITE. <br />HOLE SAW SIZE CHART <br />2-1/2" for F -17 -XX, F -10 -XX <br />A.3) RECOMMENDED: Use the Sanding kit (Page 4, sanding <br />gun sold seperately) to lightly abrade each hole until the surfaces <br />are flat and even and white fiberglass is open and visible.(Fig. A3). <br />,LTH <br />DO NOT OVERGRIND!! MAINTAIN A MINIMUM WALL THICKNESS OF 1/8" INCH. <br />For other manufacturers, lightly grind off any gel -coat or gloss finish until flat. <br />Replace any gel -coat or fiberglass that is removed in excess. <br />Follow Manufacturers Installation Instructions. <br />5 ii -F -Series -1 X -SS -11 A <br />