Laserfiche WebLink
STEP D1) Get your injection syringes and your adhesive kits ready. See Page 4 or 9. <br />The amount of adhesive shown on the Adhesive chart on page 8 must be measured and <br />injected into EACH port on the fitting. Each fitting has two ports. One inside and one outside. <br />STEP D2) Mix your approved adhesive kit with the provided fiberglass filler. Load your syringe <br />by placing the tip in the can of mixed adhesive and drawing it up. PURGE THE AIR FROM THE <br />SYRINGE TIP (Pg. 9) <br />STEP D3) Quickly inject the adhesive into the Adhesive Injection Port, which is located at the top <br />of each fitting body. The paste should flow into the interior channel and seep out along the conduit. <br />(Fig. D3) <br />DO NOT ATTEMPT TO INJECT BOTH SIDES AT ONCE <br />INJECT >< INJECT <br />ADHESIVE ADHESIVE <br />OUTSIDE INSIDE <br />FIRST A SECOND Adhesive <br />�l ���1� / <br />Injection <br />` � comptett <br />e <br />Fig. D3 <br />USE ONLY ROBROYTM PVC -COATED CONDUIT <br />or any brand hot -dip galvanized conduit <br />bead with <br />gloved finger <br />Outside of Sump <br />bead with <br />gloved finger <br />Inside of Sump <br />STEP D4) Run adhesive around the joints and bead with a gloved finger and let cure. (Fig D3) <br />10 <br />JUN0 8 H_F Series -1X -SS -11A <br />ENVIRONMENTAL HEALTH <br />