Laserfiche WebLink
Material Safety Data Sheet Page 4 of 8 II <br /> SECTION 8 EXPOSURE CONTROLSiPERSONAL PROTECTION <br /> GENERAL CONSIDERATIONS: <br /> Consider the potential hazards of this material(see Section 3), applicable exposure limits,job activities, and other <br /> substances in the work place when designing engineering controls and selecting personal protective equipment. If <br /> engineering controls or work practices are not adequate to prevent exposure to harmful levels of this material, the <br /> personal protective equipment listed below is recommended. The user should read and understand all <br /> instructions and limitations supplied with the equipment since protection is usually provided for a limited time or <br /> under certain circumstances. <br /> ENGINEERING CONTROLS: <br /> Use process enclosures, local exhaust ventilation, or other engineering controls to control airborne levels below <br /> the recommended exposure limits. <br /> PERSONAL PROTECTIVE EQUIPMENT <br /> '[ Eye/Face Protection: No special eye protection is normally required. Where splashing is possible, wear safety <br /> 1• giasses with side shields as a good safety practice. <br /> Skin Protection:Wear protective clothing to prevent skin contact. Selection of protective clothing may include <br /> gloves, apron, boots, and complete facial protection depending on operations conducted. Suggested materials for <br /> protective gloves include: Chlorinated Polyethylene (or Chlorosulfonated Polyethylene), Nitrite Rubber, <br /> Polyurethane, Viton.. <br /> Respiratory Protection: Determine if airborne concentrations are below the recommended occupational <br /> exposure limits for jurisdiction of use. If airborne concentrations are above the acceptable limits, wear an <br /> approved respirator that provides adequate protection from this material, such as:Air-Purifying Respirator for <br /> Organic Vapors. <br /> When used as a fuel, this material can produce carbon monoxide in the exhaust. Determine if airborne <br /> concentrations are below the occupational exposure limit for carbon monoxide. if not, wear an approved positive- <br /> pressure air-supplying respirator. <br /> Use a positive pressure air-supplying respirator in circumstances where air-purifying respirators may not provide <br /> adequate protection. <br /> Occupational Exposure Limits: <br /> Component Agency JITWA STELIlCelling Notation <br /> Diesel Fuel No. 2 ACGIH 100 mg/m3 —Skin A3 <br /> Diesel Fuel No. 2 11CVX 350 rng/m3 1000 mglm3 1— 7� <br /> Kerosine _ _ ACGIH 200 m6 Skin A3 <br /> Kerosine CVX 350 mg1m3 1000 mglm3 E <br /> Naphthalene ACGIH 10 ppm(weight) 15 ppmSkin <br /> (weight) �� <br /> Naphthalen 110SHA Z-1 50 mg/m3 <br /> SECTION 9 PHYSICAL.AND CHEMICAL PROPERTIES <br /> Attention: the data below are typical values and do not constitute a specification. <br /> Color: Varies depending on specification <br /> Physical State: Liquid <br /> Odor: Petroleum odor <br /> pH: Not Applicable <br /> Vapor Pressure: 0.04 kPa (Approximate) @ 40 °C(104 °F) <br /> Vapor Density (Air= 1): >1 <br /> Boiling Point: 175.6°C (348°F) -370°C (698°.F) . <br /> Solubility: Soluble in hydrocarbons; insoluble in water <br /> CFreezing Point: Not Applicable <br /> httns://www.cbest.chevron.corn!msdsServer/controller?modide=com.cbevTon.lubes-msds..-- 11/15/2004 <br />