WORK PLANS - Laserfiche WebLink

Home Browse Search

Material Safety Data Sheet Page 4 of 8 %woe Nome SECTION 8 EXPOSURE CONTROLS/PERSONAL PROTECTION +� GENERAL CONSIDERATIONS: Consider the potential hazards of this material (see Section 3), applicable exposure limits,job activities, and other substances in the work place when designing engineering controls and selecting personal protective equipment. If engineering controls or work practices are not adequate to prevent exposure to harmful levels of this material, the personal protective equipment listed below is recommended. The user should read and understand all instructions and limitations supplied with the equipment since protection is usually provided for a limited time or under certain circumstances. ENGINEERING CONTROLS: Use process enclosures, local exhaust ventilation, or other engineering controls to control airborne levels below the recommended exposure limits. PERSONAL PROTECTIVE EQUIPMENT Eye/Face Protection: No special eye protection is normally required. Where splashing is possible, wear safety '-' glasses with side shields as a good safety practice. Skin Protection: Wear protective clothing to prevent skin contact. Selection of protective clothing may include gloves, apron, boots, and complete facial protection depending on operations conducted. Suggested materials for protective gloves include: Chlorinated Polyethylene (or Chlorosulfonated Polyethylene), Nitrile Rubber, Polyurethane, Viton.. Respiratory Protection: Determine if airborne concentrations are below the recommended occupational exposure limits for jurisdiction of use. If airborne concentrations are above the acceptable limits, wear an approved respirator that provides adequate protection from this material, such as: Air-Purifying Respirator for Organic Vapors. When used as a fuel, this material can produce carbon monoxide in the exhaust. Determine if airborne concentrations are below the occupational exposure limit for carbon monoxide. If not, wear an approved positive- pressure air-supplying respirator. Use a positive pressure air-supplying respirator in circumstances where air-purifying respirators may not provide adequate protection. Occupational Exposure Limits: LP+ Component Agency TWA STEL g Diesel Fuel No. 2 ACGIH 100 mCeilinNotation glm3 _ Diesel Fuel No. 2Skin A3 CVX 350 mg/m3 1000 mg/m3 _ ++ Kerosine ACGIH 200 mg/m3 _ KerosineSkin A3 CVX 1350 mg/m3 1000 mglm3 — 1 Naphthalene ACGIH 10 ppm (weight) 15 ppm �Skin �.+ (weight) Naphthalene OSHA Z-1 50 mg/m3 _ SI=CTION 9 PHYSICAL AND CHEMICAL PROPERTII=S t. Attention: the data below are typical values and do not constitute a specification. Color: Varies depending on specification Physical State: Liquid `+ Odor: Petroleum odor pH: Not Applicable Vapor Pressure: 0.04 kPa (Approximate) @ 40 °G (104 °F) LA Vapor Density (Air= 1): >1 Boiling Point: 175.6°C (348°F) - 370°C (698'F) Solubility: Soluble in hydrocarbons; insoluble in water Freezing Point: Not Applicable *r haps://www.ebest.chevron.com/msdsServer/controller?module=com.chevron.Iubes.msds.... 11/15/2004