Laserfiche WebLink
Material Safety Data Sheet Wage 4 of 8 <br /> SECTION 8 EXPOSURE CONTROLSIPERSONAL PROTECTION <br /> GENERAL CONSIDERATIONS: <br /> _ Consider the potential hazards of this material(see Section 3), applicable exposure limits,job activities, and other <br /> substances in the work place when designing engineering controls and selecting personal protective equipment. If <br /> engineering controls or work practices are not adequate to prevent exposure to harmful levels-of this material, the <br /> personal protective equipment listed below is recommended. The user should read and understand all <br /> instructions and limitations supplied with the equipment since protection is usually provided for a limited time or <br /> under certain circumstances. <br /> ENGINEERING CONTROLS: <br /> Use process enclosures, local exhaust ventilation, or other engineering controls to control airborne levels below <br /> the recommended exposure limits. <br /> PERSONAL PROTECTIVE EQUIPMENT <br /> Eye/Face Protection: No special eye protection is normally required. Where splashing is possible, wear safety <br /> glasses with side shields as a good safety practice. <br /> Skin Protection:Wear protective clothing to prevent skin contact. Selection of protective clothing may include <br /> gloves, apron, boots, and complete facial protection depending on operations conducted. Suggested materials for <br /> protective gloves include: Chlorinated Polyethylene(or Chlorosulfonated Polyethylene), Nitrile Rubber, <br /> Polyurethane, Viton.. <br /> Respiratory Protection: Determine if airborne concentrations are below the recommended occupational <br /> exposure limits for jurisdiction of use. If airborne concentrations are above the acceptable limits, wear an <br /> approved respirator that provide' adequate protection from this material, such as: Air-Purifying Respirator for <br /> Organic Vapors. <br /> When used as a fuel, this material can produce carbon monoxide in the exhaust. Determine if airborne <br /> L concentrations are below the occupational exposure limit for carbon monoxide. If not,wear an approved positive- <br /> pressure air-supplying respirator. <br /> Use a positive pressure air-supplying respirator in circumstances where air-purifying respirators may not provide <br /> adequate protection. <br /> Occupational Exposure Limits: <br /> Component Agency JJTWA JISTEL Ceiling Notation <br /> Diesef Fuel No.2 ACGIH 100 mg/m3 0 Skin A3 <br /> LDiesel Fuel No.2 ocvx 11350 mg/m3 i000 mglm3 <br /> Kerosine ACGII{ 200 mglm3 Skin A3 <br /> Kerosine 11cm 11350 mglm3 1000 nng/m3 <br /> Naphthalene ACGIH 10 ppm(weight) 15 ppm Skin <br /> (weight) <br /> Naphthalene OSHA Z-1 150 mg1m3 <br /> SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES <br /> Attention: the data below are typical values and do not constitute a specification. <br /> Color: Varies depending on specification <br /> Physical State: Liquid <br /> Odor: Petroleum odor <br /> pH: Not Applicable <br /> L Vapor Pressure: 0.04 kPa (Approximate) @ 40 °C(104 °F) <br /> Vapor Density (Air= 1): >1 <br /> Boiling Point: 175.6'C (348°F) -370'C (698'.F) . <br /> Solubility: Soluble in hydrocarbons; insoluble in water <br /> Freezing Point: Not Applicable <br /> httDsJ/www.cbest.chevron.corn/msdsServer/controtler.rnodiile—com.chevron_]ubes_rrtsds_.__ 11/15/2004 <br />