Laserfiche WebLink
0 <br />PHIL - T I TE ENTERPR I SES <br />85000-1 Series Spill Collector <br />MAINTENANCE INSTRUCTIONS <br />Every 3 Years Or Following Spill Collector Installation <br />Perform the Following: <br />1. Inspect the black spill bucket and remove any standing liquid, grit, sand, <br />debris or dirt from inside the spill bucket. <br />2. Perform CARB test procedure TP -201.1 D - Leak Rate of Drop Tube <br />Overfill Prevention Devices and Spill Container Drain Valves. <br />3. If the drain valve assembly, drop tube and spill bucket passes testing, no <br />further maintenance is necessary. If the drop tube, or the drain valve <br />assembly, or the spill bucket fails testing perform the steps listed below. <br />4. Annual liquid leak testing — See the 85000-1 Series annual leak testing <br />protocol instructions when performing this test. <br />Spill Collector Maintenance Instructions <br />• Check the product swivel adaptor for any leakage. Any leakage from the swivel <br />adaptor seal or thru the swivel adaptor will mask the test results toward failure. <br />Eliminate any leakage thru the product swivel adaptor. See step 1. <br />• If the drain valve is suspected of leaking perform steps 2 thru 6. <br />• If the spill bucket to riser adaptor/tank riser flat seal and/or the drop tube seal are <br />suspected of leaking perform steps 7 thru 10. <br />• Note: The drop tube must be installed under the spill collector. If not this could <br />possibly be the source of any leaks. Install the drop tube under the spill collector. <br />1. Check the product swivel adaptor for any leakage. See product and vapor swivel <br />adaptor maintenance instructions. Replace the flat seal if suspected of leaking. <br />2. Remove the snap -ring from the inside of the spill bucket. Ensure the gray foam <br />filter (UF8005) is free of any debris, grit, sand, dirt, and liquid. The purpose of the <br />foam filter is to trap and hold any debris (grit, dirt, sand, etc.) from reaching the <br />drain valve and drain holes, blocking them from draining properly. This filter <br />greatly improves the longevity and proper operation of the drain valve assembly. <br />Replace the foam filter if it is torn, has tears, and/or damage. Phil-Tite <br />Enterprises will provide replacement foam filters (UF8005) free of charge. <br />3. With the snap ring removed, loosen and remove the drain valve top hex screw <br />from the top clamp. With the drain valve handle position in the middle of the spill <br />bucket remove the drain valve and handle assembly by pulling up on the valve <br />handle. <br />Page 49 of 194 <br />1 of 2 <br />