Laserfiche WebLink
FIBERGLASS -COMPOSITE PIPE GROUP <br />Fittings Dimensions in <br />2 through 6 -inch Sizes <br />for Dualoy 30001 piping systems <br />Units <br />All dimensions are in U.S. Customary units (inches). <br />Diametric dimensions are maximums. <br />Insertion depths (X1. Xz) are typical. <br />All weights (lb) are approximate. <br />Tolerances <br />Tolerance for centerline -to -face dimensions on fittings with bell -end <br />configuration is ±1/16 inch. <br />Listings <br />Dualoy 3000/L is Listed in the U.S. with Underwriters Laboratories for nonmetallic <br />underground piping for motor vehicle (MV), high blend (HB), concentrated (CT) and <br />U <br />O Underwriters�� <br />aviation and marine (A&M) fuels (File MH9162). Dualoy 3000/L pipe and fittings are <br />also listed with Underwriters Laboratories of Canada (File CMH 715). In Great Britain <br />Laboratories Inc: <br />the Dualoy 3000/1- system has been tested and accepted by the London Fire and <br />Civil Defence Authority. Dualoy 3000/1- has been issued a Certificate of Compliance <br />to the Institute of Petroleum (IP) Specification by ERA Technology, Ltd. <br />End configurations <br />Bell end is standard. <br />Taper angle <br />The taper angle on all bell and spigot end configurations is 13/4° <br />Pressure ratings <br />See Ameron publication DUALoy 3000/L FIBERGLASS PIPE AND FITTINGS, FP265, for <br />pressure ratings. <br />Individual system components may not have the same ratings as the pipe. Refer <br />to the detailed product information for the specific components to determine the <br />pressure rating for the system as a whole. <br />Manufacturing methods <br />The fiberglass -reinforced epoxy resin fittings shown in this document are <br />manufactured by filament winding or compression molding. <br />Adapters: bell x NPT female Flange rings <br />Adapters: bell x NPT male Flange stub ends <br />Adapters: isolation Nipples <br />Adapters: spigot x NPT female Reducer bushings <br />Adapters: spigot x NPT male Repair couplings <br />45° Elbows Sleeve couplings <br />90° Elbows Sump penetration pieces <br />End caps Tees <br />FP266E (11/07) <br />