INSTALL 2002 - Laserfiche WebLink

Home Browse Search

Units Tolerances No Listings (#�Underwriters'laboratories Inc.® End configurations T aper angle Pressure ratings Manufacturing methods All dimensions are in U.S. Customary units (inches). Diametric dimensions are maximums. Insertion depths (X,,1^2) are typical. All weights (lb) are approximate. Tolerance for centerline -to -face dimensions on fittings with bell -end configuration is t1/1e inch. Dualoy 3000/L is Listed in the U.S. with Underwriters Laboratories for nonmetallic underground piping for petroleum products, alcohols (such as methanol and ethanol) and alcohol -gasoline mixtures (File MH9162). Dualoy 3000/L pipe and fittings are also listed with Underwriters Laboratories of Canada for petroleum products and oxygenated fuels (File CMH 715), In the Netherlands with KIWA (Ref. ATA no. 2062/1-E), in Sweden with AS Statens Anlaggningsprovning (Certificate SA 1-1- 9846) and with the French Ministry of the Environment (Arrete 261 bis). In Great Britain the Dualoy 3000/L system has been tested and accepted by the London Fire and Civil Defence Authority. Bell end isstandard. The taper angle on all bell and spigot end configurations is 1314°. See Ameron publication DUALoy 3000/1- FIBERGLASS PIPE AND FITTINGS, FP265, for pressure ratings. Individual system components may not have the same ratings as the pipe. Refer to the detailed product information for the specific components to - determine the pressure rating for the system as a whole. The fiberglass -reinforced epoxy resin fittings shown in this document are manufactured by filament winding or compression molding. Adapters: bell x NPT female Adapters: bell x NPT male Adapters: isolation Adapters: spigot x NPT female Adapters: spigot x NPT male 45° Elbows 90` Elbows End caps Flange rings Flange stub ends Nipples Reducer bushings Repair couplings Sleeve couplings Sump penetration pieces Tees FP266C 0 0/94)