Laserfiche WebLink
71 SO-TOOL PROCEDURE BELOW, STEP 10A: TIGHTEN THE 71 SO-TOOL <br /> FOR 71 SO-TOOLC, SEE PAGE 9 Use the three view holes to ensure that the tool seats <br /> FOR 71 SO -TOOLCT, SEE PAGE 10 out flat against the top of the inlet tube . To prevent <br /> vertical movement of the tool during drilling, hand <br /> Note: 71 SO -TOOL can only be used with testable tighten all three knobs evenly to the upper drop tube . <br /> overfill valves if modified as shown below. A 2" See Figure 10A . <br /> wide slot must be added to accommodate cast lug . <br /> STEP 11A: PREPARE DRILL AND BIT <br /> Add 2" wide Confirm that the stop on the 3/ 16" drill bit supplied <br /> slot to use with with the 71 SO-TOOL is in the correct position before <br /> ® testable valves drilling . The stop is factory installed at a distance be- <br /> tween 2 " to 2 - 1 / 16" from the tip with the 71 SO -TOOL . If <br /> the stop is not at the correct position it must be fixed <br /> before drilling . <br /> CAUTION : If the drill stop is not in the proper loca - <br /> o tion failure of a pressure decay leak test may result . <br /> 71 SO-TOOL Modifications for Testable Inlet <br /> STEP 9A: INSERT 71 SO-TOOL OVER INLET TUBE <br /> To install the 71 SO-TOOL (sold separately) over the inlet <br /> tube, first loosen all three knobs, so the tool can pass Tip to stop dimension must be <br /> freely over the inlet tube flange . Align the slot on the 2 " to 2 - 1 / 16". <br /> tool with the key on the inlet tube and insert the tool <br /> down . See Figure 9A. Figure 11A <br /> Loosen all Hand STEP 12A: DRILL HOLES <br /> Tool slot knobs View holes tighten With the inlet tube and 71 SO-TOOL in place, carefully <br /> kns evens drill a 3/ 16" diameter hole in the upper tube using the <br /> drill bushing in the knob as a guide. The drill stop is po - <br /> ��� sitioned so it will bottom out against the knob after the <br /> bit has drilled through the upper drop tube. If the stop <br /> is positioned wrong either no hole will be drilled , or a <br /> through hole could potentially be drilled through the <br /> Q inlet tube. If no hole is drilled return to step 11 A and <br /> Q check the stop dimension . If a hole is drilled through <br /> the inlet tube or into the screw hole the assembly is not <br /> Inlet salvageable. Drill (2) more holes in the two remaining <br /> Tube knobs. <br /> key <br /> •- Drill thru upper I <br /> Figure 9A Figure 10A tube only -/ <br /> Figure 12A <br /> 8 <br /> I <br />