ARCHIVED REPORTS XR0010689 - Laserfiche WebLink

Home Browse Search

• CALIFORNIA GEOPHYSICAL WATER SAMPLING PROTOCOLS Water Sampling Procedures : The equipment used to withdraw water from the well will be a PVC or stainless steel bailer or an electric pump. All equipment including the bailers, bailing cord, water depth measuring devise, pump, electric lines and hose must be decontaminated prior to entering any well . They will be decontaminated by washing with nonphesphate detergent and rinsed with tap water. The well will be measured, purged, remeasured and a water sample will be taken immediately after remeasuring. ' MEASURING The dept: to groundwater will be measured from the highest point on the top of the casing to the surface of the water table. This point is marked with black on the casing. The measuring devise I used will be an electric conductivity devise which trips a red light anal/or a buzzer when the prone tcuche, wa_,r. A minimum cf three measurements will be made at each well , t=e final reading will be noted after 2 or more readings do not vary by more that. I 0 . 01 feet. The total depth of the well will also he measure! . This information along with water parameters mentioned late= will he entered onto the sampling sheet. The casing volune will be lie calcz1ated according tc the formula s cclied on samzl ng sneet. FLOATING FREE PRODUCT The presence of floating free product will he checked by recording the depth of the water and marking that level cn the probe wire . The probe and wire will be withdrawn from the well and dried. Liquid paste or chalk will he placed on the probe and up the side of the wire for 2 feet (could be higher depending cn the depth of the plune) . The prose is then carefully lowered into the well so that the probe lust touches the water table , care will be taken not to lower the probe below the water table . Once the probe has buzzed at the water table it is withdrawn ' quickly from the well and the liquid level above the water level Fount on the probe is recorded. This differential between the liquid level and the probe water sensing point is the floating Product thickness and will be recorded on the sampling sheet. Water samples will be obtained as follows : A) First, one casing volume of water will be withdrawn from the well , I E) The parameters of pH, conductivity and temperature will be measured. The color, odor and presence of a sheen of the purged fM water will be noted; C) A 2nd and 3rd casing volume of water will be withdrawn and the Parameters remeasured, if the results from the third measuring