Laserfiche WebLink
TESTABLE PROCEDURE ONLY, FOR STANDARD MOD STEP 3T: DETERMINE CABLE LENGTH <br /> ELS, PROCEED TO NEXT PAGE, I Run cable along upper tube and over the top plate on <br /> the float bracket as shown . With the float in the down <br /> STEP 1T: INSTALL SOCKET ADAPTOR ASSY position (as shown in Figure 3T) align loop in cable with <br /> Put cable thru threads in inlet tube and out thru cable rivet and top hole in float bracket. Use the rivet as a <br /> port on side of inlet tube. Thread the socket adaptor template to size the loop in the cable and pull cable <br /> assembly finger tight into the inlet tube. Note: the ca- tight and crimp ferrule with crimping tool / pliers onto <br /> ble port on the inlet tube must be in line with the float cable at this location. Trim excess cable with wire cut- <br /> as shown previously in Figure 8A. ter / scissors. For reference, from the seam where the <br /> upper tube and valve body meet to the end of the cable <br /> Socket after trimming will require approximately 3 .5" of cable. <br /> adaptor <br /> assembly ` Cable over float bracket <br /> Cable Seam <br /> port <br /> Figure 3T <br /> STEP 4T: ATTACH CABLE TO FLOAT BRACKET <br /> Figure 1T Ensure cable is over the float bracket. Using the sup- <br /> plied rivet align loop in cable with top hole in float <br /> STEP 2T: PASS CABLE THRU FERRULE bracket and pass rivet thru cable loop and float bracket <br /> Pass cable thru ferrule. Loop cable and then pass cable hole. Using rivet tool for 1 /8" dia mandrel attach rivet <br /> back thru ferrule. Keep ferrule loose until cable length and cable to the float bracket. See last page for list of <br /> is determined in the next step. Note: if cable end frays replacement cable parts. <br /> it may be necessary to trim the cable again to pass thru <br /> ferrule. _�-` Attach rivet to top hole <br /> 4,ive <br /> x <br /> Figure 4T <br /> Trim STEP 5T: ENSURE PROPER CABLE OPERATION <br /> cable /' Unthread the socket adaptor assembly from the inlet <br /> after tube and ensure float and poppet move freely when <br /> step 3T socket adaptor assembly is pulled on . It should only <br /> require 3 " to 4" of movement in order to actuate the <br /> Figure 2T float and poppet. Thread socket adaptor assembly fin- <br /> ger tight into inlet tube after testing . <br /> 13 <br />