Laserfiche WebLink
2 . To determine lower tube distance from tank <br /> bottom to bottom of cut: <br /> Subtract valve length (W) from distance to tank <br /> bottom (B) <br /> (V) = (B) — (W) = <br /> Cast lug <br /> Note: Lower tube clearance must meet tank manufac- in 71 SO <br /> turer requirements and all AHJ, local, state, and national / body <br /> codes. Typical clearance is about 4". If lower tube clear- ✓/ Float direction <br /> ance is not met valve must be removed and adjusted to <br /> meet these requirements. <br /> 3 . To determine lower tube distance from tank <br /> bottom to top of cut: <br /> Subtract valve length (U) from distance to tank <br /> bottom (B) <br /> (T) = (B) — (U ) = <br /> View into drop tube from above <br /> Note: Lower tube distance from tank bottom to top of <br /> cut must meet all AHJ, local, state, and national codes. <br /> For reference per 40 CFR 63 subpart CCCCCC / NESHAP <br /> the lower tube can be no more than 6" from the bottom <br /> of the tank. If lower tube distance is not met valve must <br /> be removed and adjusted to meet these requirements. <br /> 4. To determine float alignment: <br /> Looking into upper tube (see figure) the float should be <br /> aligned along the length of the tank. If float is not <br /> aligned properly adjustments need to be made. <br /> 22 <br />