Laserfiche WebLink
ISSUED: <br />REVISED: <br />MODEL No: <br />Accessory Specialties AMERICAN DISPENSER Desert Ray Products ,INC. <br />THIS MANUFACTURER RESERVES THE RIGHT TO MAKE CHANGES IN DESIGN OR DIMENSIONS WITHOUT FORMAL NOTICE <br />SURFACE MOUNTED TWIN HIDE-A-ROLL TOILET TISSUE DISPENSER <br />0030AMERICAN SPECIALTIES, INC. <br />www.americanspecialties.com <br />441 Saw Mill River Road, Yonkers, NY 10701 (914) 476-9000 01-87 <br />01-08 <br />SPECIFICATION <br />Surface Mounted Twin Hide-A-Roll Toilet Tissue Dispenser shall hold and dispense two (2) standard or two (2) 5- <br />1/4" diameter (Ø133) 1800 sheets tissue rolls and shall have door, door frame, and dispensing mechanism fabricated <br />of alloy 18-8 stainless steel, type 304, 18 gauge; cabinet body shall be same grade, 22 gauge. All exposed surface <br />shall be No 4 satin finish and be protected during shipment with a PVC film easily removable after installation. <br />Internal mechanism levers shall be fabricated of molded high-impact resistant plastic for smooth operation. Structural <br />assembly of body and door components shall be of welded construction. Door hinge shall be of heavy-duty stainless <br />steel 3/16" diameter (Ø4.8). Door shall be held closed with a tumbler lock keyed alike to other ASI washroom <br />equipment. Cabinet shall include theft resistant and vandal resistant rollers that shall be of molded high-impact <br />resistant plastic with integral molded-in stainless steel end pins and two (2) rollers [p/n R-004] shall be supplied. <br />Surface Mounted Twin Hide-a-Roll Toilet Tissue Dispenser shall be Model No 0030 as manufactured <br />by American Specialties, Inc. 441 Saw Mill River Road Yonkers, New York 10701-4913 <br />INSTALLATION <br />Unit is surface mounted on wall or partition using four (4) No10 self-tapping screws (by others). Top two mounting <br />holes through back are “keyhole” slots for ease in hanging unit on pre-installed screws. Bottom two mounting holes <br />are horizontal slots for ease of adjustment. For compliance with ADA Accessibility Guidelines, top of unit should be <br />installed 29" (737 mm) above finished floor. <br />OPERATION <br />Reloading instructions are printed on graphic label inside door. Bottom roll is depleted prior to top roll <br />automatically dropping into lower position for use. Empty rollers can not be removed without key unlocking door. <br />6" <br />[152] <br />12" <br />[305] <br />2-12" <br />[64] <br />7" <br />[178] <br />3" <br />[76] <br />1-12" <br />[38] <br />PIN TUMBLER <br />LOCK <br />MOUNTING HOLES <br />CONCEALED ON <br />REAR WALL <br />HINGE PIVOT <br />3" <br />[76] <br />6-12" <br />[165] <br />11-7 8" <br />[302] <br />5-3 4" <br />[146] <br />NOTE: ALL DIMS ARE INCH [MM] <br />10099