Laserfiche WebLink
GFTTLER-RYAN INC. GR Job# 20-641017 <br /> D. Results of Testing/Servicing <br /> Software Version Installed: 334.00 <br /> Complete the following checklist: <br /> ry Yes ❑ o Is the audible alarm operational? <br /> E Yes ❑ No' Is the visual alar operational? <br /> [i—Yes ❑ No' Were all sensors visually-inspected,functionally tested,and confirmed operational?---- <br /> E Yes ❑ No' Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their <br /> proper operation? <br /> Yes ❑ No' If alarms are relayed to a remote monitoring station,is all communication equipment(e.g.modem)operational? <br /> ❑ N/A <br /> F, Yes ❑ No' For pressurized piping systems,does the turbine automatically shut down if the piping secondary containment monitoring system <br /> ❑ N/A detects a leak,fails to operate,or is electrically disconnected?If yes:which sensors initiate positive shut-down?(Check all that apply) <br /> E Sump/Trench Sensor; G Dispenser Containment Sensor.Did you confirm positive shut-down due to leaks and sensor <br /> failure/disconnection? [j Yes; ❑ No. <br /> [d Yes ❑ No` For tank systems that utilize the monitoring system as the primary tank overfill warning device(i e.no mechanical overfill prevention <br /> ❑ N/A valve is installed),is the overfill warning alar visible and audible at the tank fill point(s)and operating property?If so,at what percent <br /> of tank capacity does the alarm trigger? 90 <br /> ❑ Yes No Was any monitoring equipment replaced?If yes,identify specific sensors,probes,or other equipment replaced and list the <br /> manufacturer name and model for all replacement parts in Section E,below. <br /> ❑ Yes No Was liquid found inside any secondary containment systems designed as dry systems?(Check all that apply) ❑Product, []Water. If <br /> yes,describe causes in Section E.below. <br /> FA Yes ❑ No' Was monitoring system set-up reviewed to insure proper settings?Attach set-up reports,if applicable. <br /> E Yes ❑ No' Is all monitoring equipment operational per manufacture's specifications? <br /> In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> Monitoring System Certification Page 2 of 4 12/07 <br /> 2 <br />