Laserfiche WebLink
D. Results of Testing/Servicing <br />Software Version Installed: !�• W <br />Complete the following checluist: <br />es <br />❑ <br />No* <br />Is the audible ala <br />_ <br />es <br />❑ <br />No* <br />Is the visual al <br />El es <br />❑ <br />No* <br />Were all sensors <br />Zj Yes <br />❑ <br />No* <br />Were all sensors <br />not interfere with <br />❑ Yes <br />❑�� <br />If alarms are r <br />!a <br />N/A <br />operational? <br />jet' Yes <br />❑ <br />No* <br />For pressurized p <br />❑ <br />N/A <br />monitoring syste <br />positive shut -do <br />Did you confirm <br />❑ Yes <br />❑ �To* <br />For tank systems <br />N/A <br />mechanical over <br />fill point(s) and o <br />❑ Yes* <br />No <br />Was any monitor' <br />and list the manu <br />❑ Yes*VNo <br />Was liquid found <br />❑ Product; ❑ W <br />Yes <br />❑ <br />No* <br />Was monitoring s <br />rm operational? <br />arm operational? <br />visually inspected, functionally tested, and confirmed operational? <br />installed at lowest point of secondary containment and positioned so that other equipment will <br />their proper operation? <br />elayed to a remote monitoring station, is all communications equipment (e.g. modem) <br />iping systems, does the turbine automatically shut down if the piping secondary containment <br />m detects a leak, fails to operat r is electrically disco ed? If yes: which sensors initiate <br />wn? (Check all that apply) Sump/Trench Sensors; Dispenser Containment Sensors. <br />positive shut -down due to leaks and sensor failure/disconnection? Yes; ❑ No. <br />that utilize the monitoring system as the primary tank over -till warning device (i.e, no <br />fill prevention. valve is installed), is the overfill warning alarm visible and audible at the tank <br />perating properly? If so, at what percent of tank capacity does the alarm trigger? % <br />mg equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced <br />facturer name and model for all replacement parts in Section E, below. <br />inside any secondary containment systems designed as dry systems? (Check all that apply) <br />ater. If yes, describe causes, in Section E, below. <br />ystem set-up reviewed to ensure proper settings?. Attach set up reports, if applicable <br />Yes ❑ No* Is all monitoring equipment operational per manufacturer's specifications? <br />* In Section E below, describe how and when these deficiencies were or will be corrected. <br />E. Comments: <br />