COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

B31W4451 CANCER INFORMATION For complete discussion of toxicology data refer to Section 11. SECTION 4- FIRST AID MEASURES EYES: Flush eyes with large amounts ofwater for 15 minutes.Get medical attention. SKIN: Wash affected areathoroughly with soap and water. Remove contaminated clothing and launder before re-use. INHALATION: Ifaffected,remove from exposure. Restore breathing.Keep warm and quiet. INGESTION: Do not induce vomiting.Get medical attention immediately. SECTION 5- FIRE FIGHTING MEASURES FLASHPOINT LEL UEL FLAMMABILITY CLASSIFICATION Not Applicable Not Not Not Applicable Applicable Applicable EXTINGUISHING MEDIA Carbon Dioxide,Dry Chemical,Alcohol Foam UNUSUAL FIRE AND EXPLOSION HAZARDS Closed containers may explode(due to the build-up of pressure)when exposed to extreme heat. During emergency condiltions overexposure to decomposition products may cause a health hazard.Symptoms may not be immediately apparent.Obtain medical attention. SPECIAL FIRE FIGHTING PROCEDURES Full protective equipment including self-contained breathing apparatus should be used. Water spray may be ineffective. If water is used,fog nozzles are preferable.Water may be used to cool closed container;to prevent pressure build-up and possible autoignition or explosion when exposed to extreme heat. SECTION 6-ACCIDENTAL RELEASE MEASURES STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED Remove all sources of ignition.Ventilate the area. Remove with inert absorbent. SECTION 7- HANDLING AND STORAGE STORAGE CATEGORY Not Applicable PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE Keep container closed when not in use.Transfer only to approved containers with complete and appropriate labeling.Do not take internally. Keep out of the reach of children. SECTION 8- EXPOSURE CONTROLS/PERSONAL PROTECTION PRECAUTIONS TO BE TAKEN IN USE Use only with adequate ventilation. Avoid contact with skin and eyes.Avoid breathing vapor and spray mist. Wash hands after using. This coating may contain materials classified as nuisance parliculates(listed"as Dust"in Sedion 2)which may be present at hazardous levels only during sanding or abrading ofthe dried film.If no specific dusts are listed in Section 2,the applicable limits for nuisance duds are ACGIH TLV 1D mg/m3(total dud), 3 mg/m3(respirable fraction),OSHA PEL 15 mg/m3(total dud),5 mg/m3(respirable fraction). Removal of old paint by sanding,scraping or other means may generate dud or fumes that contain lead.Exposure to lead dust or fumes may cause brain damage or other adverse health effects,especially in children or pregnant women.Controlling exposure to lead or other hazardous substances requires the use of proper protective equipment,such as a properly fifted respirator(NIOSH approved)and proper containment and cleanup.For more information,call the National Lead Information Center at 1-8D0424-LEAD(n US)or contact your local health authority. VENTILATION Local exhaust preferable.General exhaust acceptable iflhe exposure to materials m Section 2 is maintained below applicable exposure limits.Refer to OSHA Standards 191D.94, 1910.107,191DAD8, RESPIRATORY PROTECTION If personal exposure cannot be controlled below applicable limits by ventilation,weara properly filed organic vapor/particulate respirator approved by NIOSHMISHA for protection against materials in Section 2. Men sanding or abrading the dried film,wear a dusVmist respirator approved by NIOSHM A fordust which may be generated from this product, underlying paint,or the abrasive. PROTECTIVE GLOVES Wear gloves which are recommended by glove supplier for protection against materials in Section 2. EYE PROTECTION Wear safety spectacles with unperforated sideshields. page 2 of 4