COMPLIANCE INFO 2010 - 2012 - Laserfiche WebLink

Home Browse Search

JUN-24-2010 06:33 Service Station Systems 408 938 8888 P.05 Monitoring System Certification- Pak if 3 Site Address: 2448 W. Kettleman Ln. Date ofresting/Servicing: 5124110 D. Results of Testing/Servicing Software Version Installed- 122.00 Complete the foliowin checklist: 3 Yes ❑ No* Is the audible alarm operational? 2 Yes ❑ No's Is the visual alarm operational? z Yes ❑ No* Were all sensors visually inspected, functionally tested, and confirmed operational? Ig Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not interfere with their proper operation? ❑ Yes to No* if alarms are relayed to a remote monitoring station, is all communications equipment(e.g. modem) IN N/A operational? Ig Yes C1 No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment ❑ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive shut-down? (Check all that ripply) Z Sump/Trench Sensors; ❑ Dispenser Containment Sensors. Did you confirm positive shut-down due to leaks and sensor failure/disconnection? IX Yes ❑ No ❑ Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i,e. no lg N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank fill point(s) and operating properly? if so, at what percent of tank capacity does the alarm tri er? 0 %, Ix Yes* ❑ No Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E, below_ ❑ Yes* [X No Was liquid found inside any secondary containment systems designed as dry systems? (Check all[hat apply) ❑ Product;❑ Water. if ves,describe causes in Section E. below. 18 Yes ❑ No* Was monitorings stem set-up reviewed to ensure proper settings? (Attach set-up reports, ifa; licable.) Yes [] No* Is all monitoring equipment operational per manufacturer's specifications? * In Section E below, describe how and when these deficiencies were or will he corrected. E. Comments; Replaced 89 Mechanical Leak Detector. Rewired 87 STP 208 sensor. Checked for ball floats -not located where required by inspector. Need to replace 87, 89 & 91 straight drop tubes with flappers. Technician Bryan Lundien installed drop tubes wlflapperss on 5/25110