COMPLIANCE INFO 2007 - 2009 - Laserfiche WebLink

Home Browse Search

SWRCB,January 2002 Page 6 of 10 6. PIPING SUMP TESTING Test Method Developed By: ❑Sump Manufacturer X Industry Standard ❑Professional Engineer ❑Other(Spec) Test Method Used: ❑Pressure ❑Vacuum X Hydrostatic ❑Other(Specify) Test Equipment Used:Incon TS STS Equipment Resolution: Sump—R.P.S. Sump—P.P.S. Sump- Sump- Sump Diameter: 42" 42" Sump Depth: 60" 64" Sump Material: Fiberglass Fiberglass Height from Tank Top to Top of 12" 12" Highest Piping Penetration: Height from Tank Top to Lowest 22„ 23" Electrical Penetration: Condition of sump prior to testing: Clean Clean Portion of Sump Tested' Full Full Does turbine shut down when sump sensor detects liquid(both X Yes ❑No ❑NA X Yes ❑No ❑NA ❑Yes ❑No ❑NA ❑Yes ❑No 11NA product and water)?* Turbine shutdown response time 2 Seconds 2 Seconds Is system programmed for fail-safe X Yes ❑No ❑NA X Yes ❑No ❑NA ❑Yes ❑No ❑NA ❑Yes ❑No ❑NA shutdown?* Was fail-safe verified to be X Yes ❑No ❑NA X Yes ❑No ❑NA ❑Yes ❑No ❑NA ❑Yes ❑No ❑NA operational?* Wait time between applying pressure/vacuum/water and starting 15 minutes 15 minutes test: Test Start Time: 11:21 11:21 Initial Reading(RI): 6.3062" 6.3528" Test End Time: 11:36 11:36 Final Reading(RF): 6.3057" 6.3521" Test Duration: 15 minutes 15 minutes Change in Reading(RF-R,): Loss.0005" Loss.0007" Pass/Fail Threshold or Criteria: Loss<.002"amass Loss<.002"amass Test Result: X Pass ❑Fail X Pass ❑Fail ❑ Pass ❑Fail ❑ Pass ❑Fail Was sensor removed for testing? X Yes ❑No ❑NA X Yes ❑No ❑NA ❑Yes ❑No ❑NA ❑Yes ❑No ❑NA Was sensor properly replaced and X Yes ❑No ❑NA X Yes ❑No ❑NA ❑Yes ❑No ❑NA ❑Yes ❑No ❑NA verified functional after testin ? Comments—(include information on repairs made prior to testing, and recommended follow-up for failed tests) Install new SSI test boots at the ends of all of the piping runs in the sumps and UDC's Verify that they have no leaks with soapy water. Tighten all clamps on the entries including the electrical. Plug the opening in the transition boot of the rock guard. ' If the entire depth of the sump is not tested,specify how much was tested. If the answer to gny of the questions indicated with an asterisk(*)is"NO"or"NA",the entire sump must be tested. (See SWRCB LG-160)