Laserfiche WebLink
/�����+ ' <br />CONTACT I'- "OR MORE INFORMATION! <br />5555 Skylane Blvd., Su. A / Santa Rosa, CA 95403 <br />Ph: (800) 688-3375 / Fx: (800) 700-1188 <br />www.westemfg.com <br />Prepare coupling fitting and attach Co -Flex termination fitting (male or <br />female) to connector within sump area/s. Tighten. <br />Position pipe within trench. Lay out piping runs while maintaining <br />separation between pipe lengths and at crossover points. <br />TEST & CROSSOVER BOOT/TUBING INSTALLATION: <br />The Test/Crossover Assembly Boots are attached to the Co -Flex Piping <br />ends to provide a sealed access and test point for the <br />interstitial/secondary space within the pipe. The Test/Crossover Boots <br />utilizes two (2) #28 stainless steel hose clamps which when tightened <br />around the termination fitting swage sleeve and the Co -Flex outer jacket <br />isolate the interstitial space. An air valve stem is installed in the boot on <br />the bottom for an outlet opening for connecting the crossover and/or test <br />tubes. These tubes are used for the testing of and the interconnection of <br />the interstitial space from pipe section to pipe section. Crossover tube <br />assemblies are used for junctions within dispenser sumps, pipe to pipe in <br />line connections, piping run termination points, tank sump connection <br />points and any piping manifold connection points. <br />Test/Crossover Boots and tubes are fitted and tightened in place after the <br />piping terminations and their connections have been made. <br />After installation and tightening of all test and crossover boots and tubes <br />pressure testing may be done. (See Above). <br />Page 12 of 38 <br />