Laserfiche WebLink
CONTACT FOR MORE INFORMATION! <br />5555 Skylane Blvd., S A / Santa Rosa, CA 95403 <br />Ph: (800) 688-3375 / Fx: (800) 700-1188 <br />` www.westemtg.com <br />roller tool to "roll-out" air bubbles gently, so as not to displace putty. <br />Remove all bubbles. Apply additional layers of material in some manner. <br />Your laminate should appear clear, with no air bubbles or pockets in view <br />and all fasteners covered. If additional resin is required, use only resin from <br />Western Fiberglass, Inc. The resin used in construction of all Western <br />Fiberglass, Inc. components is corrosion resistant resin, made for use in fuel <br />and chemical applications. <br />BACKFILL REQUIREMENTS: <br />Sufficient backfill must be used below and along the sump side to provide <br />support and protection against ground movement. <br />TEST PROCEDURES FOR SINGLE WALL: <br />After the sump to tank fitting is completed, you shall test the integrity of <br />your seal. This is important to insure that the sump riser tube / tank bond <br />will not allow any contained fluid to leak. Check with local regulations for <br />required testing procedures. A common test procedure is to fill the sump <br />with water after the sump / tank bond has completely cured, usually <br />overnight, and observe bond seam for any <br />leaks. <br />PLEASE NOTE: U.L. Listed sumps require a listed, approved, electronic monitor/alarm system <br />to be installed for operator notification in the event of product leakage within sump area. <br />TEST PROCEDURES FOR DOUBLE WALL: <br />After completion of the sump body test as described above, you may test <br />the sump body interstitial space by applying no more than 2 psi to the <br />port(s) installed within the sump body. The annular space may also be <br />tested using liquid or vacuum. For test times or other requirements, always <br />follow local regulations and restrictions. <br />PLEASE NOTE: U.L. Listed sumps require a listed, approved, electronic monitor/alarm system <br />to be installed for operator notification in the event of product leakage within sump area. <br />Page 35 of 38 <br />