Laserfiche WebLink
MAN <br /> a. A <br /> yt� <br /> 6.2 w„ <br /> ATTACHME.W C <br /> HALF-FACE RESPIRATOR INSTRUCTIONS <br /> Ins ection Pilcedures — <br /> 1. Look for breaks or tears in the headband material: also stretch <br /> to check the elasticity. <br /> 2. hake sure all headbands, fasteners and adjusters are in place <br /> and not bent. <br /> F <br /> ` 3. Check the f4cepiece for dirt, cracks, tears or holes. The <br /> rubber should be flexible, not stiff. <br /> j.d <br /> 4. Loci? at the shape of the faeepiece for possible distortion that <br /> may occur if the respirator is not protected during storage. : <br /> �. 5. Check the exhalation valve located near the chin between: the <br /> cartridges. <br /> is a. Unsnap the cover. <br /> j � <br /> b. Lift the Valve and inspect the seat and valve for cracYz., <br /> i <br /> tears, dirt or distortion. <br /> c. Replace the cover. It should spin freely. <br /> Check both inhalation vales (inside the h cartridge <br /> 'Look 'for same signs as above. g alders). <br /> 7. Check the yoke for cracks. <br /> 8. hake sure the cartridge Czolders are cl?an. Mase sure the <br /> ��..a ga�skrta a_e in place and the threads are not worn. Also look <br /> t., for cracks and other dam,9ge. <br /> ' F 9. Check the cartridges for dents or :-ather dsaage, especially in <br /> the threaded part. <br /> G <br /> Donring Procedures <br /> 1f 1. Screw the cartridge into the holder hand tight so that there is <br /> a good seal with casket in the uattam of the holder, but don't <br /> fore it. If tt:e cartridge won't go in easily, back it out and <br /> try again. ¢� <br /> Always use cartridges made b� the same :manufacturer who Made <br /> the respirator. - <br /> t. Place the facepiece over the bridge of yoar nosw and swing the <br /> bottom in so that it rests against your chin. <br /> JJ <br /> i; <br />