Laserfiche WebLink
LEVEL PROBE <br /> INSTALLATION INSTRUCTIONS <br /> r <br /> oom"" <br /> INC <br /> 1. The Level Probe must be placed above the level of the pump inlet and far enough away to keep it from be- <br /> ing sucked towards the pump(s). <br /> 2. The Level Probe must be placed so that it is at least 1 foot away from touching anything in the wet well. <br /> 3. The Level Probe must not be placed so that the Inflow pours directly onto the Level Probe. However, to aid <br /> in keeping it clean, the Inflow may be allowed to splash liquid up onto the Probe. <br /> 4. Do not run the Level Probe's cable in a conduit with pump power cables or float switch wiring. The Level <br /> Probe's cable must be run in a separate conduit away from all AC wires or cables. <br /> 5. Do not place the Level Probe's cable near the pump power cables. Leave at least 1 foot separation. <br /> 6. The Mounting Bracket and Squeegee should be mounted as shown below. Adjust the height of Level Probe <br /> and secure the cable to the S-Hook with two Tie Straps. <br /> 7. Leave enough slack in cable between the S-Hook and the entrance to the conduit, to allow for the raising of <br /> the Level Probe during routine cleaning. <br /> 8. Seal the conduit at the control panel or junction box to prevent corrosive gases from entering. <br /> 9. Connect the Level Probe wires to a terminal block in the control panel or junction box as shown below. The <br /> wiring from the terminal block to the pump control device(s) should be routed separate from all A/C wiring. <br /> 10. The liquid in the wet well must be grounded to the control panel ground. Where a submersible pump is pre- <br /> sent the grounded housing of the pump is sufficient. If there is no other means to ground the liquid, a single <br /> point Level Probe may be placed near the bottom of the wet well and connected to control panel ground. <br /> 11. Periodic cleaning of the Level Probe should be done by pulling or pushing it through the Squeegee. <br /> MOUNTING BRACKET 8 SQUEEGEETO PUMP <br /> 0 0 0 0 CONTROLS <br /> 11 <br /> S-HOOK <br /> ® ® ® 0 0 <br /> SEE I� GROUND 1 2 3 4 5 6 7 8 9 10 <br /> NOTES `TIE STRAPS <br /> 485 �► <br /> SEE <br /> NOTE 7 <br /> INFLOW <br /> t <br /> ELECTRODE�2 <br /> SEE y <br /> NOTE 2 <br /> 3 <br /> 4 <br /> ..-SEE-. <br /> 5 <br /> NOTE 3 <br /> '-LEVEL 6 <br /> PROBE <br /> 7 <br /> 8 <br /> LIQUID <br /> LIQUID 9 <br /> 10 <br /> PUMP SEE <br /> NOTE 1 <br /> PUMP INI�1 SEE NOTE 10 <br /> LJ I.-1 tJ_L1 WET WELL WET WELL <br /> 2464 Vulcan Road, Apopka, Florida 32703 (407) 299-3825 • www.mpelectronics.com <br />