Laserfiche WebLink
GR Field Methods and Procedures <br /> Storinc and Sampling of Drill Cuttin s <br /> Drill cuttings are stockpiled on plastic sheeting or stored in drums depending on site conditions and <br /> regulatory requirements Stockpile samples are collected and analyzed on the basis of one <br /> composite sample per 50 cubic yards of soil Stockpile samples are composed of four discrete soil <br /> samples, each collected from an arbitrary location on the stockpile The four discrete samples are <br /> then composited in the laboratory prior to analysis <br /> Each discrete stockpile sample is collected by removing the upper 3 to 6 inches of soil, and then <br /> driving the stainless or brass sample tube into the stockpiled material with a hand, mallet, or drive <br /> sampler The sample tubes are then covered on both ends with Teflon sheeting, capped, labeled, <br /> and placed in a cooler with blue ice for preservation A chain-of-custody form is initiated in the <br /> field and accompanies the selected soil samples to the analytical laboratory Stockpiled soils are <br /> covered with plastic sheeting after completion of sampling <br /> Wellhead Surve <br /> The top of the newly-installed well casing is surveyed by a California-licensed Land Surveyor to <br /> mean sea level (MSL) <br /> Well Develoement <br /> The purpose of well development is to improve hydraulic communication between the well and <br /> surrounding aquifer Prior to development, each well is monitored for the presence of separate- <br /> phase hydrocarbons and the depth-to-water is recorded Wells are then developed by alternately <br /> surging the well with the bailer, then purging the well with a pump to remove accumulated <br /> sediments and draw groundwater into the well Development continues until the groundwater <br /> parameters(temperature, pH, and conductivity) have stabilized <br /> Groundwater Monitoring and Sampling <br /> Decontamination Procedures <br /> All physical parameter measuring and sampling equipment are decontaminated pnor to sample <br /> collection using Alconox or equivalent detergent followed by steam cleaning with deiomzed water <br /> During field sampling, equipment placed in a well are decontaminated before purging or sampling <br /> the next well by cleaning with Alconox or equivalent detergent followed by steam cleaning with <br /> deionized water <br /> A-3 <br />