ARCHIVED REPORTS XR0006812 - Laserfiche WebLink

Home Browse Search

1 MMAA� custody. Soil samples were analyzed for BTEX using EPA method 8020, and TPHG using EPA method 8015. Analysis was performed by Sequoia Analytical Laboratory, a State certified ' analytical laboratory. The monitoring wells were developed using a bladder pump and bailing until well water was clear and filter pack fully developed. Prior to sampling, depth to groundwater measurements were collected and the well heads were surveyed. ' Subsequent to installation, development, and stabilization of electrical conductivity, pH and temperature, groundwater samples were collected from the monitoring wells. Groundwater samples were collected, using a dedicated teflon bailer, sealed in glass containers, labeled and transported on ice in the above mentioned method. Samples were analyzed for BTEX using EPA method 8020, TPHG and TPHD using modified EPA method 8015. 5.0 RESULTS OF-INVESTIGATION 5.1 Soils The soils encountered during drilling activities were predominantly fine grained soils, interbedded lenses of elastic silts with sand to lean clay with sand. One soil sample was collected from each well and boring at the soil/groundwater interface, approximately 6 feet below grade. The samples were analyzed for BTEX and TPHG by EPA methods 8020 and modified 8015, respectively. Additionally the sample collected from the iboring near the waste oil tank (SB 11) was analyzed for cadmium, chromium, zinc and lead by ' EPA methods 7421 and 6010. ' Benzene (0 11 ppm), toluene (0.14 ppm), ethylbenzene (0 047 ppm), xylenes (0.23 ppm) and total petroleum hydrocarbons as gasoline (2 6 ppm) were detected in the soil sample collected from MW1 Benzene (2.8 ppm), toluene (2.4 ppm), ethylbenzene (7 2 ppm), xylenes (22 ppm) 4 and total petroleum hydrocarbons as gasoline (990 ppm) were detected in sods collected from F R-012792 LF 5