WORK PLANS - Laserfiche WebLink

Home Browse Search

0 Steel toe safety shoes or boots • Safety Glasses • Hearing Protection (if necessary) Note: Contaminants are anticipated in some, if not most, areas of subsurface work; should evidence of contamination become apparent,then protective gloves, including a latex liner and chemical resistant outer gloves and Tyvek-coverall will be required(see selection criteria below). In addition, latex over-boots(disposable)or reusable chemically resistant over-boots or steel toe over the sock rubber boots will be necessary. Provisions for decontamination must be established at any exclusion zone where non-disposable outer boots are to be worn. For operations which require work gloves to protect the hands from abrasion, sharp edges, etc., leather (or equivalent) work gloves may be worn OVER chemical resistant gloves. Such gloves will be dedicated to exclusion zone work, but must be assumed to be chemically contaminated once put into service. Upgrades of additional equipment may be mandated by the FSS based upon conditions or activities. Substitutions other than those described in this section are permissible only upon approval by the FSS. 8.2 Level C Protection Consists of the addition of the following respiratory protection to the Level D ensemble (Section 8.1): • Full face air purifying respirators with combination HEPA/organic vapor/acid cartridges. • Eyeglass inserts MUST be provided for those employees who require prescription eyewear. 8.2.1 Criteria for Upgrading to Level C The presence of any one of the following conditions shall be sufficient to require Level C PPE. • Verified detection of combustible gas levels in the breathing zone using the combustible gas meter. The detection of methane is likely to be an indication of the presence of other contaminants. • "Verified" organic vapor levels in the breathing zone, as measured by PID: Santochi&Bravante LLC American Savings Bank 20 Corporate Plaza 9620-041-1 Newport Beach,California 13 222 El Dorado