Laserfiche WebLink
34 BOLTED STAINLESS STEEL FITTING <br /> 341 The bolted stainless steel fitting shall be constructed with 1 ea inside flange with studs (A),2 ea <br /> fitting gaskets(B), 1 ea outside flange (C), and the correct number of lock washers (D), and hex nuts <br /> (E)for the fitting specified Refer to Figure 3 4 for part identification <br /> C <br /> C <br /> D <br /> TFG;DROVING TIBffBWG <br /> SELENE IS SL&=EP <br /> FOR THE BOLTS <br /> 1 <br /> B 5 e <br /> Li 3 4 <br /> A � s <br /> INSICF TANK WALL SLIRFAEE 2 <br /> Figure 3 4 <br /> 342 Disassemble the fitting as shipped by removing the hex nuts, lock washers, outside flange and <br /> outside flange gasket Locate the fitting hole on the inside of the tank and insert the fitting's studs <br /> through the drilled holes in the tank A gasket(B)should be between the inside fitting flange and <br /> the inside tank wall Place the outside flange gasket and outside flange over the studs on the <br /> outside surface of the tank. Install the lock washers and hex nuts on the studs Check to make <br /> sure the fitting assembly appears as shown in Figure 3 4. <br /> 343 To obtain proper gasket compression,tighten all the fitting nuts hand tight with a deep socket <br /> using the bolt tightening sequence shown until the gasket engages the tank wall and the lock <br /> washers are compressed Tighten each nut an additional 1-1f4-2 turns using the same <br /> sequence(do not tighten more than 1 turn at a time) Do not apply more than 15 ft -lbs of <br /> torque A light application of lubricating oil is necessary to prevent thread seizing on S S bolts <br /> Gasket compression should be between 25-50% Recheck gasket tightness periodically <br /> 3.5 SNYDER UNITIZED MOLDED OUTLET- (SUMOTm)(PATENT NO.5,374,026) <br /> 3 5 1 The SUMO fitting shall be constructed with 1 ea smaller o-ring (A), 1 ea larger o-nng (B), and 1 <br /> ea SUMO adapter(C) Refer to Figure 3 5 for part identification NOTE-The tank Is shipped <br /> with a shipping stabilizer Installed in the SUMO outlet. NEVER move the container without <br /> the shipping stabilizer installed <br /> METAL I;S11 <br /> TANK MAL( <br /> INTO TA <br /> i <br /> a <br /> N VIEW OF ASSENEL� C <br /> SUMO FITTING <br /> . Figure 3 5 <br /> 9 <br />