Laserfiche WebLink
Redi-Flo4"Variable Performance Motor Lead Installation <br /> INSTALLING THE MOTOR LEAD TO THE MOTOR <br /> 1 Before attaching the pump end to the motor, locate motor lead socket on the submersible motor (See Figure 1) <br /> •`� 2 Clean the motor lead socket of debris and moisture <br /> with a clean cloth <br /> 3 Align the motor lead plug within the motor lead -o---ill road <br /> socket <br /> A properly aligned plug will align over the screw "Rotor Lead ulotorStud <br /> Motor Lead Plug <br /> holes located on the motor Pigg screw <br /> 4 To secure the motor lead plug to the motor, insert the �, O-4mm <br /> motor lead plug screws (as supplied in the kit PIN Acceptable <br /> 790491) into the motor lead plug and tighten evenly toGap <br /> Screw Holes i t r-. .4--M� ed <br /> r La <br /> 18 in-lbs The bottom of the motor lead plug should e _ socket <br /> be flush with the top of the motor as shown in <br /> Figure 1 Up to 1 mm gap is acceptable between the piie <br /> center of the motor lead plug and the top of the <br /> motor as shown in Figure 1 Figure 1 <br /> 5 Motor is ready to be attached to pump end <br /> 6 Refer to pump installation instructions, regarding installation <br /> of the cable guard to protect the motor lead <br /> CABLE JOINT SPLICING INSTRUCTIONS <br /> Included with the Redi-Flo Variable Performance Motor is a watertight splice kit that is to be used to connect the motor lead <br /> and the connector(as supplied PIN, 1138583) <br /> The steps below must be followed to ensure a water tight splice <br /> 1 Remove the connector from plastic bag a �, <br /> 2 Insert the wires of the connector through the threaded opening in the " <br /> wellseal and tighten (if a well seal is being used) ShnnkTube " <br /> Wire Connector <br /> 3 With the connector secured in the well seal, slip a shrink tube <br /> (as supplied, PIN 96022795) over each individual wire before y <br /> crimping the wire connectors (See Figure 2) <br /> 4 Place the blue striped end of each wire connector (as supplied, PIN Figure 2 <br /> 96022795) over each 16 gauge wire and crimp in place, using a bare <br /> terminal crimping tool <br /> 5 Clean,dry and then strip back the motor lead wire ends 318 of an inch <br /> 6 Match color coded wires of the motor lead with the matching colored <br /> wires of the connector <br /> The white wire of the connector matches to the yellow motor <br /> lead were Insert matched wires into wire connectors and crimp <br /> (See Figure 2) f <br /> Figure 3 <br /> 7 Center the shrink tubing over each wire connector (See Figure 3) <br /> 8 Apply heat to shrink tubing,working from the center outward,to avoid <br /> air pockets Shrink tubing to connector one at a time A heat gun or <br /> propane torch with diffuser tip is recommended for shrinking the _ <br /> . tubing Sealing is complete when the shrink tube conforms to the <br /> shape of the connector and wire, and sealant flows from each end <br /> of the shrink tube (See Figure 4) <br /> If using a propane torch KEEP HEAT SOURCE MOVING. DO <br /> NOT OVERHEAT <br /> Figure 4 <br /> 9 The pump/motor is now ready for installation <br />