Laserfiche WebLink
i iECENEC! <br />MAR 0 9 2015 <br />[_NVIRONMENTAI <br />1. Using wire nuts, connect the two -wire sensor cable to the field wires in the sensor junction box (see Figure 2). Note, the <br />Sump Sensor wiring has no polarity. <br />i • Black <br />To From <br />Console i i Seal off i Sensor <br />Red <br />_*�'1/2" rigid } <br />conduit I <br />Epoxy sealed connections in a <br />weatherproof junction box <br />Figure 2. Sensor Field Wiring Diagram <br />2. Do NOT terminate drain wire at this location, ground drain wire at console only. <br />3. Seal wire nuts with epoxy sealant following the instructions in Figure 3. <br />® 4 O <br />CAUTION: Epoxy sealant is irritating to eyes, respiratory system, and skin. Can cause allergic skin reaction. Contains: epoxy <br />resin and Cycloaliphatic epoxycarboxylate. Precautions: Wear suitable protective clothing, gloves, eye, and face protection. <br />Use only in well ventilated areas. Wash thoroughly before eating, drinking, or smoking. <br />4. Push the epoxy sealed bag into the junction box. Replace and tighten the junction box cover. <br />F., <br />1 -1 <br />Instructions: <br />NOTE: When temperature is below 50`F (10'C), keep <br />resin in a warm place prior to mixing (e.g., in an <br />inside pocket next to body). <br />1. Open epoxy sealant package, and remove resin pak. <br />2. Holding resin pak as shown in A, bend pak along long <br />length. <br />3. As shown in B, firmly squeeze the RED SIDE of the <br />resin, forcing it through the center seal and into <br />BLACK SIDE. <br />CFrom probe, <br />sensor, or <br />transducer To console <br />Make sure that <br />the ends of cable <br />sheathing are sub <br />merged in sealant Tie wrap <br />Wire nuts <br />4. Mix thoroughly to a uniform color by squeezing <br />contents back and forth 25-30 times. <br />5. Squeeze mixed, warm resin into one end of bag and <br />cutoff other end. <br />6. Slowly insert wiring connections into sealing pack <br />until they fit snugly against the opposite end as <br />shown in C. <br />7. Twist open end of bag and use tie wrap to close it off <br />and position the tie wrapped end up until the resin <br />jells. <br />conso1es\epzy2w.eps <br />Figure 3. Epoxy Sealing Field Connections <br />5. Consult the appropriate console site prep manual to connect the Sump Sensor to the console. <br />5 <br />