ARCHIVED REPORTS XR0009290 - Laserfiche WebLink

Home Browse Search

Geological Tech&ks Inc Page 5 ' Groundwater Monitoring Report Project No 723 2 October 25,2005 1.2 Groundwater Sampling Procedure ' On August 26, 2005, Del-Tech Geotechnical Support personnel arrived on-site, opened the wells and measured the depth to water with an electrically actuated sounding tape The water level readings were recorded to an accuracy of 0 01 feet In wells where free-floating product ' is suspected, a clear disposable bailer is used to gauge the interface During this monitoring no free product was noted (this procedure is not exercised in the CMTTM wells due to their limited diameter) ' Stagnant water in the well casing was purged using a Waterraum as recorded in the field p p logs (Appendix C) The rate of well purging was monitored The wells were purged of approximately three casing volumes and until the groundwater parameters (temperature, conductivity and pH) had stabilized (Appendix C) indicating that water representative of ' actual aquifer conditions was entering the well Groundwater parameter stabilization was characterized by three successive readings within 10% Wells MW-7, MW-8, MW-9 & MW-108 went dry before three well volumes were purged Before a sample was collected, ' the well's water level was allowed to recharge to at least 80% of the initial level The purge water was placed in a properly labeled 55-gallon DOT (Department of Transportation 17-H) approved container and temporarily stored on-site The dedicated Waterra pump was used to collect each monitoring well sample Care was exercised while transferring the sample into 40-m1 VOA vials preserved with hydrochloric ' acid All samples were checked for headspace bubbles, labeled, inserted into foam holders and placed into an ice chest cooled to 4°C for transport to the laboratory ' The sampling technician wore disposable gloves while collecting all samples A chain of custody document, listing all samples collected and their intended analyses, ' accompanied the samples from the field to the laboratory, thereby providing a means to track the movement of the samples and ensure their integrity ' 1.3 Laboratory Analyses The groundwater samples collected on August 26, 2005, were delivered to Excelchem ' Environmental Labs of Roseville, California (certification #2119) for analyses of ❑ Benzene, Toluene, Ethyl Benzene, and Xylene (BTEX) by EPA method 8260B ❑ Total Petroleum Hydrocarbons as Gasoline (TPH-G) by EPA method 8260B ❑ MTBE, DIPE, ETBE, TAME, TBA, 1,2 DCA, EDB by EPA method 8260B ' The detection limits for the above analyses are listed in Table 5 of Appendix A, while the lab analytical results are presented in Appendix B