Laserfiche WebLink
1 <br /> Geological rec ida la Page 5 <br /> ' Groundwater Monitoring Report <br /> Project No 723 2 <br /> June 21,2000 <br /> Stagnant water in the well casing was purged using a Waterra pump as recorded in the field <br /> logs (Appendix C) The rate of well purging was monitored The wells were purged of <br /> ' approximately three casing volumes and until the groundwater parameters (temperature, <br /> conductivity and pH) had stabilized (Appendix C) indicating that water representative of <br /> actual aquifer conditions was entering the well Groundwater parameter stabilization was <br /> characterized by three successive readings within 10% Before a sample was collected, the <br /> well's water level was allowed to recharge to at least 80% of the initial level The purge <br /> water was placed in a properly labeled 55-gallon DOT (Department of Transportation 17-H) <br /> approved container and temporarily stored on-site <br /> The dedicated Waterra pump was used to collect each monitoring well sample Care was <br /> ' exercised while transferring the sample into 40-m1 VOA vials preserved with hydrochloric <br /> acid All samples were checked for headspace bubbles, labeled, inserted into foam holders <br /> ' and placed into an ice chest cooled to 4°C for transport to the laboratory <br /> The sampling technician wore disposable gloves while collecting all samples <br /> ' A chain of custody document, listing all samples collected and their intended analyses, <br /> accompanied the samples from the field to the laboratory, thereby providing a means to track <br /> the movement of the samples and ensure their integrity <br /> 1.3 Laboratory Analyses <br /> The groundwater samples collected on April 17, 2006, were delivered to California <br /> Laboratory Services of Rancho Cordova, California (certification #1233) for analyses of <br /> ' ❑ Benzene, Toluene, Ethyl Benzene, and Xylene (BTEX) by EPA method 8260B <br /> ❑ Total Petroleum Hydrocarbons as Gasoline (TPH-G) by EPA method 8015M <br /> ❑ MTBE, DIPE, ETBE, TAME, TBA, 1,2 DCA, EDB by EPA method 8260B <br /> The detection lirruts for the above analyses are listed in Table 5 of Appendix A, while the lab <br /> analytical results are presented in Appendix B <br /> As required under AB2886, groundwater elevation and laboratory data were submitted <br /> q <br /> electronically to GeoTracker on June 16, 2006 - confirmation numbers 3325439274 & <br /> ' 6115549802, respectively <br /> ' 2.0 FINDINGS AND DISCUSSION <br /> ' Groundwater samples were obtained from the existing wells and from the top three screened <br /> intervals in each of the CMVm wells <br /> 1 <br /> The results of the groundwater sample analyses indicate the following <br />