ARCHIVED REPORTS XR0009888 - Laserfiche WebLink

Home Browse Search

' Bank of Stockton -Cutter Lumber Site Page 3 Quarterly Groundwater Monitoring Report Project No 102 2 January 21,2002 ' 2.0 GROUNDWATER MONITORING The following sections describe the procedures associated with the completion of ' groundwater monitoring at the site along with documenting the disposal of the well purge water associated with groundwater monitors ig activity ' 2.1 Groundwater Sample Collection ' On December 5, 2001, Del-Tech Geotechnical Services of Oakdale, CA mobilized to the site to complete groundwater monitoring The groundwater monitoring procedure was as follows Upon arrival, each well was opened and the water ' level allowed to equilibrate As each well was opened and prior to taking the depth to groundwater measurement, a PID organic vapor meter was used to screen for VOC's in the head space of the well The dopth to groundwater was ' then measured by lowering an electronically actuated air 1 water interface detector suspended from a polyethylene measuring tape calibrated to the nearest 0 01 foot (see groundwater monitoring data sheets in Appendix B) A careful ' notation made of the depth to groundwater as measured by the device No measurable free product was observed in the wells Each well was pumped with a dedicated Wattera pump or by inserting a submersible pump into the well and lowering it to bottom Well water was containerized in 55-gallon DOT approved polyethylene drums, properly labeled, and temporarily stored on-site The rate of well purging was monitored, and each well was purged of at least three casing volumes Dr until the groundwater ' parameters (temperature, conductivity, and pH) had stabilized indicating that water representative of actual aquifer conditions ,vas entering the well Groundwater parameter stabilization was characterized by three successive readings within 10 percent After the wells had been allowed to recharge to at least 80 percent of their original volume, samples were collected from them using methods described below A stainless steel bailer belayed on a clean stainless steel line was used to collect each sample Bailer cleanliness was verified by collecting a bailer blank ' (pouring distilled water through the bailer and collecting it in a VOA vial) prior to collecting the analytical sample Before and in bei ween uses, all sampling i equipment was washed using a portable steam cleaner Disposable gloves were worn by the sampling technician while collecting all s Lmples The gloves were changed between the collection of each sample to redu(e the potential for cross- contamination 2937 Veneman Ave ,#13240 Geo-Phase Environmental Inc Phone (209) 569-0293 Modesto, CA 95356 Fax (209) 569-0293