Laserfiche WebLink
APPENDIX A <br /> SAMPLING AND ANALYSIS PROCEDURES <br /> The sampling procedures for water quality monitoring programs are contained in this appendix <br /> The procedures provided for consistent and reproducible sampling methods, proper application <br /> of analytical methods, and accurate and precise analytical results Finally, these procedures <br /> provided guidelines so that the overall objectives of the monitoring program were achieved <br /> The following documents have been used as guidelines for developing these procedures <br /> • Procedures Manual for Groundwater Monitoring at Solid Waste Disposal Facilities, <br /> Environmental Protection Agency (EPA)-530/SW-611, August 1977 <br /> • Resource Conservation and Recovery Act (RCRA) Groundwater Monitoring Technical <br /> Enforcement Guidance Document, Office of Solid Waste and Emergency Response <br /> (OSWER)9950 1, September 1986 <br /> • Test Methods for Evaluating Solid Waste Physical/Chemical Methods, EPA SW-846, <br /> 3rd edition, November 1986 <br /> • Methods for Organic Chemical Analysis of Municipal and Industrial Waste Water, <br /> EPA-600/4-82-057, July 1982 <br /> • Methods for Organic Chemical Analysis of Water and Wastes, EPA-600/4-79-020, <br /> revised March 1983 <br /> • Leaking Underground Fuel Tank (LUFT) Field Manual, California State Water <br /> Resources Control Board, revised October 1989 <br /> Sample Collection <br /> Sample collection procedures include equipment cleaning, water level and total well depth <br /> measurements, and well purging and sampling <br /> Equipment Cleaning <br /> •�, Before the sampling event was started, equipment that was used to sample groundwater was <br /> disassembled and cleaned with detergent water and then rinsed with deionized water During <br /> gpc\D\QMR\3RDQTR-1\2130Q398 DOC-98Usg L A-1 ;V"MW(e <br /> Rev 0,5/8/98 <br />