Laserfiche WebLink
Bonded Sump Entry Fitting - Termination Style <br /> for Fuel Handling applications <br /> Installation and Application Instructions <br /> 1. Determine entry hole location and cut entry hole in sump <br /> wall using appropriate "C" dimensions in Table 1. <br /> 2. Using 40-60 grit fresh emery cloth or sand paper, sand <br /> the sump wall surfaces,inside and outside,to the outside <br /> diameter of the alignment rings.All glazed surface must <br /> be removed. Once finished sanding, remove all dust <br /> from the sanded area with a clean, dry cloth or brush. , <br /> Do not use compressed air or bare fingers. <br /> 3. Place two alignment rings on sump entry fitting and <br /> insert through sump wall from outside the sump. Locate �. <br /> the 1/4 inch threaded outlet to the desired angular ,, <br /> location. <br /> If this fitting is used in an Open (Drainage) System, <br /> locate the 1/4 inch threaded outlet in the 6 o'clock <br /> position. System 3x2 Part No. 4x3 Part No. <br /> Leave 1/4 inch plastic threaded outlet protector in place <br /> until 1/4 inch fitting installation. Red Thread IIA or 012030-626-0 012040-626-0 <br /> Dualoy 3000/1- <br /> 4. <br /> 000/L4. Dry fit primary pipe and rotate the two rings until the <br /> desired angle is reached. Maximum allowable offset is Dualoy 3000/LCX* 22856830 33856830 <br /> 50. *Includes Closure Nipple <br /> Make alignment marks on the rings, the sump entry <br /> fitting, and the sump wall. Be sure to mark the rings so <br /> they can be placed in the same location and sequence <br /> during bonding. <br /> SUMP WALL <br /> OUTSIDE <br /> Dimensions SUMP <br /> TABLE 1 -Fitting <br /> Size A B C INSIDE <br /> Inch Inch Inch Inch SUMP A <br /> 3 x 2 6.88 4.00 4.00 B <br /> 4 x 3 6.88 4.00 5.00 <br /> NOTE:These fittings can only be bonded to flat walled, _ _ <br /> fiberglass sumps.DO NOT install on thermoplastic or C -T <br /> round sumps. <br /> HOLE <br /> DIA <br /> NT ENTRY TERMINATION <br /> RETAINING ALIGNME <br /> FITTING BODY <br /> RING RINGS <br /> 0` Fiber Glass Systems <br />