Laserfiche WebLink
11/04-05/93 <br /> Burners and Controls replaced burner and pilot assembly. <br /> 1X/05/93 <br /> Unit off on arrival, restart and Adjust unit after was <br /> repaired Collect bag samples of MW1, MW2/3, MW10, Ex, <br /> influent, and effluent for WEGE laboratory System set at <br /> of air dilute . <br /> 11/17/93 <br /> Unit running on arrival . Adjust unit and sample Collect bag <br /> sample of influent for WEGE laboratory System set at 0% Air <br /> dilute. <br /> 11./30/93 <br /> Unit running on arrival Adjust unit and sample. Collect bag <br /> samples of influent and Effluent for WEGE laboratory <br /> System set at Ov air dilute. <br /> 12/07/93 <br /> Unit running on arrival . Adjust unit and sample Collect bag <br /> sample of influent for WEGE laboratory System set at 015 air <br /> dilute <br /> 12/16/93 <br /> Unit shut down due to mechanical failure As of January 1, <br /> 1993 , the Unit had not been restarted <br /> The VOC emissions have never exceeded the 52 lb/day emission limit <br /> for the site No evidence of Tetrachloroethylene {PCE} was found <br /> during examination of the chromatograms of the samples taken to the <br /> WEGE laboratory <br /> VAPOR SAMPLING <br /> COLLECTING LABORATORY SAMPLES <br /> Influent Sample <br /> The influent sample is obtained from a sample port located after the <br /> system vacuum pump before the REMOX Unit Sterile poly tubing is <br /> then used to attach a 1 liter tedlar bag, fitted with a special <br /> septum "valve" and tubing bib, to the sample port . The sample port <br /> is on the pressure side of the pump and therefore the bag will fill <br />• without need of a pump. Once the tedlar bag is filled, its valve is <br /> closed and locked; the appropriate label is placed on the tedlar <br /> bag <br /> page 2 of R603 , 01/18/94 <br />