COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

COMPONENTS WITH LIMIT VALUES THAT REQUIRE MONITORING AT THE WORKPLACE 2 , 2 ' , 2 ' ' -NITRILOTRIETHANOL 102 - 71- 6 : TLV : LONG-TERM VALUE : 5 MG/M3 2 -METHYLPENTANE- 214 - DIOL 107 - 41 - 5 : REL : CEILING LIMIT VALUE : 125 MG/M3 , 25 PPM TLV : CEILING LIMIT VALUE : 121 MG/M3 , 25 PPM ADDITIONAL INFORMATION : THE LISTS THAT WERE VALID DURING THE CREATION WERE USED AS BASIS EXPOSURE CONTROLS : PERSONAL PROTECTIVE EQUIPMENT : GENERAL PROTECTIVE AND HYGIENIC MEASURES : KEEP AWAY FROM FOODSTUFFS , BEVERAGES AND FEED . IMMEDIATELY REMOVE ALL SOILED AND CONTAMINATED CLOTHING . WASH HANDS BEFORE BREAKS AND AT THE END OF WORK . STORE PROTECTIVE CLOTHING SEPARATELY . EYE / FACE PROTECTION : TIGHTLY SEALED GOGGLES HAND PROTECTION : PROTECTIVE GLOVES THE GLOVE MATERIAL HAS TO BE IMPERMEABLE AND RESISTANT TO THE PRODUCT / THE SUBSTANCE/ THE PREPARATION . WHEN CONTACT IS LIKELY WEAR CHEMICAL RESISTANT GLOVES AND BOOTS . SELECTION OF THE GLOVE MATERIAL ON CONSIDERATION OF THE PENETRATION TIMES , RATES OF DIFFUSION AND THE DEGRADATION MATERIAL OF GLOVES : THE SELECTION OF THE SUITABLE GLOVES DOES NOT ONLY DEPEND ON THE MATERIAL , BUT ALSO ON FURTHER MARKS OF QUALITY AND VARIES FROM MANUFACTURER TO MANUFACTURER . AS THE PRODUCT IS A PREPARATION OF SEVERAL SUBSTANCES , THE RESISTANCE OF THE GLOVE MATERIAL CANNOT BE CALCULATED IN ADVANCE AND HAS THEREFORE TO BE CHECKED PRIOR TO THE APPLICATION . PENETRATION TIME OF GLOVE MATERIAL : THE EXACT BREAK THROUGH TIME HAS TO BE FOUND OUT BY THE MANUFACTURER OF THE PROTECTIVE GLOVES AND HAS TO BE OBSERVED . RESPIRATORY PROTECTION : IN CASE OF BRIEF EXPOSURE OR LOW POLLUTION USE RESPIRATORY FILTER DEVICE . IN CASE OF INTENSIVE OR LONGER EXPOSURE USE RESPIRATORY PROTECTIVE DEVICE THAT IS INDEPENDENT OF CIRCULATING AIR . SECTION 9 : PHYSICAL AND CHEMICAL PROPERTIEStop APPEARANCE : FORM : LIQUID COLOR : LIGHT YELLOW ODOR : MILD SPECIFIC GRAVITY AT 20 DEG . C ( 68 DEG . F) : 0 . 97 G/ CM3 ( 8 . 095 LBS /GAL ) DENSITY : N . D .