ARCHIVED REPORTS XR0010099 - Laserfiche WebLink

Home Browse Search

Table 1. Monitoring Wells Water Levels, con't. , Well Date Well Depth to Casing Water Floating No Sampled Depth Water Elev Elev Product (ft) (ft) (MSL ft)* (MSL ft) MW-3 9/14/95 1628 765 4794 4029 None MW-3 12/26/95 1628 746 ----- 4048 None MW-3 3/28/96 1615 6 90 ----- 41 04 None MW-3 6/27/96 1610 737 ----- 41 57 None MW-3 9/23/96 1610 816 ----- 3978 None MW-3 12/19/96 1610 725 ----- 4069 None MW-3 3/10/97 1610 716 ----- 4078 None * Casing elevation Data from Evax Technologies, Site Investigation Report, April 7, 1992 i The sampler proceeded to purge well volumes of groundwater from the well using a submersible electric purging pump (a calculation was done for each well following sounding measurements) Between each well volume purge, conductivity, pH, and water temperature readings were obtained and noted on the attached groundwater sampling information sheets Once these readings stabilized after two consecutive purge volumes aquifer water is assumed to be entering the well When the well recovered to about 80% of the initial water level, the sample was collected Purge water was stored on-site in drums The well sampling information sheets containing data on temperature, conductivity, pH, depth to water, and well volumes purged are . attached The groundwater sample was collected with a new disposable bailer The groundwater sample was then poured with minimum cavitation into the appropriate, laboratory prepared sample containers leaving no headspace The sample container was then immediately capped, labeled and placed in a chilled ice chest for shipment to Priority Environmental Laboratory in Milpitas, California (a State Certified Testing Lab) under chain-of-custody documentation Groundwater Contour Map and Flow Gradient A groundwater contour map was prepared for the data listed in Table 1 above (see Figure 1) Groundwater elevation contours were plotted to a known datum The groundwater flow direction was to the north-northeast under a calculated gradient of 0 002 The flow direction is consistent with historic observed trends, and remains relatively flat Chemical Analytical Methods and Results Three groundwater samples were analyzed using EPA Methods 5030/8015 and 602 for Total Petroleum Hydrocarbons as Gasoline (TPHG), Benzene, Toluene, Ethylbenzene and Xylene (BTEX) and Methyl-tert-butyl-ether (MTBE) The analytical results of the groundwater samples are attached and listed below (see Table 2), Mr. Ed's Project No 4090-P Page 2