Laserfiche WebLink
i <br /> �aDVANTEX'� O&WANUAL <br /> If the Biotube®needs cleaning,do the following: 6 Pull the pump and place it on a cleanable <br /> •Turn circuit breaker off at service panel surface, like the riser lid. Check the intake screen; <br /> wash off particles as necessary. Record the kinds <br /> • Switch MOA and circuit breakers in control of particles(cigarette butts,hair, lint,gum, kitty <br /> panel to "Off" litter, cloth wipes,grease build-up, etc.) on the <br /> Field Maintenance Report form. Report findings <br /> • Slide cartridge out of vault to user(for education). <br /> •If necessary, the RSV2Q valve may be removed <br /> to allow room in the riser for cleaning the <br /> Biotube' <br /> — Pull RSV2Q out of its Quick Disconnect <br /> holster (see photo next page) and place it in <br /> a plastic trash can <br /> 1 <br /> — Hose off the trash can into the tank after <br /> replacing the RSV2Q <br /> • Hold Biotube cartridge over open inlet of tank <br /> or primary compartment 7 Visually inspect the Recirculating Splitter <br /> l • Carefully spray build-up into tank Valve and verify that the liquid level in the tank <br /> is within the normal range. If low, the ball mech- <br /> • If there are significant solids in vault,remove arvsm could be jammed. Remove, disassemble, <br /> and clean it too and inspect. If high,the RSV2Q may require <br /> cleaning. Remove,disassemble,and inspect. <br /> Processing Tank <br /> i <br /> 1 If possible,verify no inlet flow when all house- <br /> hold appliances are turned off.Access the inlet <br /> inspection port for visual verification of lack of <br /> flow, If the inlet inspection port is not readily <br /> accessible, then listen for trickling water at the <br /> access port.This could indicate faulty fixtures or <br /> leaky plumbing.Check building sewer cleanout <br /> for flow. <br /> I I <br />