SU0006326 - Laserfiche WebLink

Home Browse Search

MS.Hatet Page 4 PA-0600617(SA) subject to Rule 4641 . This rule applies to the manufacture and use of cutback asphalt, slow cure asphalt and emulsified asphalt for paving and maintenance operations. Rule 9510 (Indirect Source Review) This rule was adopted to reduce the impacts of growth in emissions from all new development in the San Joaquin Valley. Rule 9510 requires applicants subject to the rule to provide information that enables the District to quantify construction, area and operational PM10 and NOx emissions, and potentially mitigate a portion of those emissions. Rule 9510 requires construction exhaust emissions to be reduced by 20 percent for NOx and 45 percent for PM10 when compared to the statewide fleet average or to pay an in lieu mitigation fee. The rule is applicable to any applicant (any person or entity that undertakes a development project), which upon full build out for a commercial/retail development is 2,000 square feet or more. An application must be filed with the District no later than concurrent with application with a local agency for the final discretionary approval. For more information and instruction, please contact the District's ISR staff by phone at (559) 230-5800 or by email at ISR(a)valleyair.org. Recommended Mitigation Measures The District encourages innovation in measures to reduce air quality impacts. There are a number of features that could be incorporated into the design/operation of this project to provide additional reductions of the overall level of emissions. (Note: Some of the measures may already exist as San Joaquin County development standards. Any measure selected should be implemented to the fullest extent possible.) The suggestions listed below should not be considered all-inclusive and remain options that the agency with the land-use authority should consider for incorporation into the project. As many energy conserving and emission reducing features as possible should be included in the project. Energy conservation measures include both energy conservation through design and operational energy conservation. Examples include (but are not limited to): Increased energy efficiency (above California Title 24 Requirements); energy efficient windows, lighting, appliances, and heating/cooling systems; programmable thermostats. For more information see www.energV.ca.gov/title24/ and www.enerqystar.gov/. Use Low and No-VOC coatings and paints. For more information see South Coast's site for No-VOC Coatings at wwvv.agmd.gov/prdas/brochures/ paintguide.html. High-albedo (reflecting) roofing material. For more information see http://eetd.Ibi.gov/cooIroof/. Features to promote energy self-sufficiency (solar water-heating systems, photovoltaic cells, solar thermal electricity systems, small wind turbines, etc.) Rebate and incentive programs are offered for alternative energy equipment. For more information see www.energy.ca.gov/renewables/, www.dsireusa.org/, and http://rredc.nrel.gov/.